Indledning
This manual provides essential instructions for the safe and effective use of your Duralast DL-1000 1000A Portable Power Station and Jump Starter. This all-in-one device combines a powerful jump starter, an air compressor, and a portable power source, designed to assist with dead batteries, flat tires, and power outages. Please read this manual thoroughly before operation and retain it for future reference.
Vigtige sikkerhedsoplysninger
Always observe the following safety precautions to prevent injury or damage to the device or vehicle.
- Læs alle instruktioner, før du bruger produktet.
- Betjen ikke enheden, hvis den er blevet tabt eller beskadiget.
- Opbevares utilgængeligt for børn.
- Brug øjenbeskyttelse, når du arbejder med batterier.
- Sørg for ordentlig ventilation under brug.
- Do not expose the unit to rain or extreme temperatures.
- Tilslut batteriet clamps in the correct polarity (positive to positive, negative to negative).
- Afbryd batteriet clampi omvendt rækkefølge (negativ først, derefter positiv).
Hvad er der i æsken
Ved udpakning skal du kontrollere, at alle nedenstående varer er til stede:
- Duralast DL-1000 1000A Portable Power Station and Jump Starter
- (3) Compressor hose adapters
- Opbevaringspose
- Brugervejledning (dette dokument)
Opsætning og første opladning
Before first use, fully charge the internal battery of the DL-1000 unit.
- Locate the integrated plug on the unit.
- Connect a standard extension cord (not included) to the integrated plug.
- Sæt forlængerledningen i en standard 120V AC stikkontakt.
- Allow the unit to charge until the battery status LEDs indicate a full charge. This may take several hours.
- Once fully charged, disconnect the extension cord and store it properly.
Note: It is recommended to recharge the unit after each use and at least every three months to maintain battery health.
Betjeningsvejledning
1. Start af et køretøj med startkabler
The DL-1000 provides a 1000 peak amp jump start suitable for various vehicles including cars, trucks, motorcycles, boats, and SUVs.
- Ensure the DL-1000 unit is fully charged.
- Turn off the ignition of the vehicle with the dead battery.
- Tilslut rød positiv (+) clamp til den positive (+) pol på køretøjets batteri.
- Tilslut sort negativ (-) clamp to a clean, unpainted metal part of the vehicle's chassis, away from the battery and fuel lines.
- Turn on the Jump Starter/USB On/Off switch on the DL-1000 unit.
- Attempt to start the vehicle. If it does not start immediately, wait a few minutes before trying again.
- Once the vehicle starts, turn off the Jump Starter/USB On/Off switch.
- Frakobl sort negativ (-) clamp først, derefter rød positiv (+) clamp.
- Opbevar klamps securely in their holders.

Image: The Duralast DL-1000 unit with its red and black jumper cables connected to a vehicle's battery terminals, demonstrating proper jump-starting connection. A hand is holding the unit by its handle.
2. Brug af luftkompressoren
The 150-PSI air compressor is suitable for inflating tires, sports equipment, and other inflatables.
- Ensure the DL-1000 unit is adequately charged.
- Attach the compressor hose to the item you wish to inflate. Use the appropriate adapter if necessary.
- Check the easy-to-read pressure gauge on the unit to monitor current pressure.
- Turn on the Compressor On/Off switch.
- Inflate to the desired pressure, regularly checking the gauge.
- Once the desired pressure is reached, turn off the Compressor On/Off switch.
- Disconnect the hose and store it, along with the adapters, in the designated storage bag.
3. Portable Power Source
The DL-1000 features a 12V DC accessory outlet and a USB port for powering and charging various devices.
- 12V DC Accessory Outlet: Plug in 12V DC appliances (e.g., car vacuums, portable coolers) directly into the outlet. Ensure the appliance's power draw does not exceed the unit's capacity.
- USB-port: Connect your USB-powered devices (e.g., smartphones, tablets) to the USB port for charging. Turn on the Jump Starter/USB On/Off switch to activate the USB power output.
Opretholdelse
Proper maintenance ensures the longevity and optimal performance of your DL-1000 unit.
- Genopladning: Recharge the unit after each use. If not used, recharge at least every three months to prevent battery discharge and damage.
- Rensning: Clean the exterior of the unit with a soft, dry cloth. Do not use harsh chemicals or abrasives.
- Opbevaring: Store the unit in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure cables are neatly wrapped and clamps are secured in their holders.
- Batteri: The internal battery is a reliable lead-acid type. It is designed for years of assistance with proper care.
Fejlfinding
If you encounter issues with your DL-1000, refer to the following common problems and solutions:
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Enheden tænder ikke eller leverer strøm. | Internt batteri er afladet. | Genoplad enheden helt. |
| Køretøjet starter ikke med startkabler. | Forkert klamp connection; severely discharged vehicle battery; unit not fully charged. | Verify correct polarity (+ to +, - to chassis); ensure unit is fully charged; allow more time between attempts. |
| Luftkompressoren puster sig ikke op. | Hose not securely attached; Compressor On/Off switch not activated; unit not adequately charged. | Check hose connections; ensure switch is ON; recharge unit. |
| USB-enheden oplades ikke. | Jump Starter/USB On/Off switch not activated; unit not adequately charged. | Ensure switch is ON; recharge unit. |
Specifikationer
| Model | DL-1000 |
| Mærke | Duralast |
| Peak Output Current | 1000 Amps |
| Luftkompressortryk | 150 PSI |
| Intern batteritype | Bly-syre |
| Stikkontakter | 12V DC Accessory Outlet, USB Port |
| Etui materiale | Polypropylene (Compact, durable, and corrosion-proof) |
| Automotive Fit Type | Universal Fit |
Garantioplysninger
Specific warranty details for the Duralast DL-1000 are typically provided with the product packaging or on the manufacturer's official website. Please refer to these sources for the most accurate and up-to-date warranty terms and conditions. Generally, warranties cover defects in materials and workmanship under normal use.
Kundesupport
For technical assistance, troubleshooting beyond this manual, or inquiries regarding parts and service, please contact Duralast customer support. Contact information can usually be found on the product packaging, the official Duralast webhjemmeside eller gennem din forhandler.





