Roborock Filter for F25 RT/F25 Combo Wet Vacuum Cleaner

1. Introduktion

This instruction manual provides essential information for the proper use and maintenance of your Roborock Filter, Model SCLWTZ09RR. This filter is specifically designed for use with Roborock F25 RT and F25 Combo wet vacuum cleaners. Adhering to these instructions will help ensure optimal performance and longevity of your vacuum cleaner's filtration system.

2. Produktet er slutview

The Roborock Filter (SCLWTZ09RR) is a crucial component for maintaining the cleaning efficiency of your F25 RT or F25 Combo wet vacuum cleaner. It captures dust, debris, and other particles, preventing them from re-entering the air and protecting the vacuum's motor. Regular inspection and maintenance of the filter are vital for consistent performance.

Figur 2.1: Forside view of the Roborock SCLWTZ09RR filter, showing its pleated design for efficient particle capture.

Figur 2.2: Vinklet top view of the Roborock SCLWTZ09RR filter, highlighting its structural design.

Figure 2.3: The Roborock filter packaging, typically containing two replacement filters.

3. Installationsvejledning

Follow these steps to properly install or replace the filter in your Roborock F25 RT or F25 Combo wet vacuum cleaner:

1. Sluk: Ensure the vacuum cleaner is turned off and unplugged from the power source before beginning any maintenance.
2. Find filterrummet: Identify the filter compartment on your Roborock F25 RT or F25 Combo. Refer to your vacuum cleaner's main manual for the exact location if unsure.
3. Fjern gammelt filter: Open the filter compartment cover. Carefully grasp the old filter and pull it out. Dispose of the old filter responsibly.
4. Indsæt nyt filter: Take a new Roborock SCLWTZ09RR filter. Align the new filter with the slot in the compartment and push it firmly until it clicks into place. Ensure it is seated correctly to prevent air leaks.
5. Luk rum: Luk filterrummets dæksel forsvarligt.

Figure 3.1: Illustration of a hand removing or inserting the filter into the designated compartment of the Roborock wet vacuum cleaner.

4. Driftsmæssige overvejelser

Once the filter is correctly installed, your Roborock F25 RT or F25 Combo wet vacuum cleaner is ready for operation. The filter works continuously during cleaning cycles to capture fine particles. To ensure optimal performance:

• Always ensure the filter is dry before re-installing it after cleaning.
• Never operate the vacuum cleaner without a filter installed, as this can damage the motor and void your warranty.
• If you notice a decrease in suction power or unusual noises, check the filter for blockages or damage.

5. Vedligeholdelse og pleje

Regular cleaning and timely replacement of the filter are essential for maintaining your vacuum cleaner's performance and extending its lifespan.

5.1. Rengøring af filteret

The Roborock SCLWTZ09RR filter is designed for hand washing:

1. Fjern filter: Follow steps 1-3 from the Installation section to remove the filter from the vacuum cleaner.
2. Skylle: Rinse the filter under cool, running water. Gently tap the filter to dislodge any trapped dirt and debris. Avoid using harsh detergents or brushes, as these can damage the filter material.
3. Tør helt: Allow the filter to air dry completely for at least 24 hours before re-installing it. Do not use a dryer or direct heat, as this can deform the filter. Ensure it is thoroughly dry to prevent mold or mildew growth.

5.2. Udskiftning af filter

It is recommended to replace the filter every 3 to 6 months, or more frequently depending on usage and cleaning environment. Signs that a filter needs replacement include:

• Noticeable decrease in suction power, even after cleaning.
• Visible damage or tears to the filter material.
• Persistent odors emanating from the vacuum cleaner.

6. Fejlfinding

Hvis du støder på problemer relateret til filteret, skal du overveje følgende:

• Reduceret sugning: Check if the filter is clogged with debris. Clean or replace the filter as necessary. Ensure the filter is installed correctly and the compartment cover is sealed.
• Usædvanlige lugte: This often indicates a dirty filter. Clean the filter thoroughly and ensure it is completely dry before re-installation. If odors persist, replace the filter.
• Filter passer ikke: Ensure you are using the correct filter model (SCLWTZ09RR) for your Roborock F25 RT or F25 Combo. Verify that the filter is aligned properly before pushing it into place.

For issues not resolved by these steps, please refer to your vacuum cleaner's main instruction manual or contact Roborock customer support.

7. Specifikationer

8. Garantioplysninger

This filter is a consumable accessory. Please refer to the warranty policy provided with your Roborock F25 RT or F25 Combo wet vacuum cleaner for details regarding accessories and replacement parts. Typically, consumable items like filters are not covered under the main product warranty for wear and tear, but may be covered against manufacturing defects for a limited period.

Always purchase genuine Roborock replacement parts to ensure compatibility and maintain your vacuum cleaner's warranty.

9. Kundesupport

For further assistance, technical support, or to purchase additional genuine Roborock filters, please contact Roborock customer service or visit the official Roborock webwebsted.

• Online support: Visit the official Roborock webwebsted for ofte stillede spørgsmål, fejlfindingsvejledninger og kontaktoplysninger.
• Kontaktoplysninger: Refer to the contact details provided in your main vacuum cleaner manual or on the Roborock webwebsted for regional støtte.