Vigtige sikkerhedsoplysninger
Please read all instructions carefully before using the DAYTECH DA10 Fridge and Freezer Door Alarm. Retain this manual for future reference.
- Denne enhed er kun beregnet til indendørs brug.
- Udsæt ikke enheden for ekstreme temperaturer, direkte sollys eller fugt.
- Keep out of reach of children to prevent accidental ingestion of small parts or batteries.
- Ensure proper battery polarity when installing.
- Bortskaf brugte batterier i henhold til lokale regler.
Produkt overview
The DAYTECH DA10 Fridge and Freezer Door Alarm is designed to alert users when a refrigerator or freezer door has been left open for a user-defined period, helping to prevent food spoilage and conserve energy.
Komponenter
- Hovedenhed: Contains the buzzer, LED indicator, and control buttons.
- Magnet: A smaller component that interacts with the main unit to detect door status.
- AAA batterier: Two AAA batteries are required and included for operation.
- Selvklæbende tape: For secure, tool-free installation.
Enhedsfunktioner
- Justerbar forsinkelse: Set the alarm to trigger after 1, 2, 3, or 4 minutes.
- Two Tones: Choose between a gentle chime or a loud alarm sound.
- Justerbar lydstyrke: Five volume levels ranging from 0 dB (mute) to 120 dB.
- Advarsel om lavt batteri: The device will indicate when batteries need replacement.
Opsætning og installation
Installation af batteri
The device requires two AAA batteries for operation. These are included with your purchase.
- Locate the battery cover on the back of the main unit.
- Slide the cover open in the direction indicated by the 'OPEN' arrow.
- Isæt to AAA-batterier, og sørg for at polariteten (+/-) vender korrekt.
- Skub batteridækslet tilbage på plads, indtil det klikker sikkert.
Montering af alarmen
The alarm can be installed on various doors, including refrigerators, freezers, cabinets, and windows, using the provided adhesive tape.
- Clean the surface where the main unit and magnet will be installed. Ensure it is dry and free of dust or grease.
- Peel off the protective film from the adhesive tape on the back of both the main unit and the magnet.
- Attach the main unit to the door frame or the fixed part of the appliance.
- Attach the magnet to the moving part of the door, ensuring it aligns with the triangular mark on the main unit.
- Vigtig: The distance between the main unit and the magnet must be less than 0.98 inches (2.5 cm) when the door is closed for proper detection.
Installationsvideoguide
Betjeningsvejledning
Power On/Off and Tone Selection
The device features a single switch for power and tone selection.
- Skub kontakten til 'CHIME' for a gentle reminder tone.
- Skub kontakten til 'ALARM' for a loud, piercing alert.
- Skub kontakten til 'OFF' to power down the device.
Justering af lydstyrke
The volume can be adjusted to suit your environment.
- Tryk på Lydstyrke-knap (located below the CHIME/ALARM/OFF switch) to cycle through 5 volume levels: 0 dB (mute), 30 dB, 60 dB, 90 dB, and 120 dB.
Setting Delay Mode
The alarm features four delay modes, allowing you to choose how long the door can remain open before an alert sounds.
- Tryk på SET-tasten (located at the bottom of the side panel) to cycle through the four available delay modes. Each press will advance to the next mode.
| Mode | Indledende forsinkelse | Alarm/Chime Frequency |
|---|---|---|
| 1 | 1 minut | Sound for 5 seconds every 15 seconds |
| 2 | 2 minutter | Sound for 10 seconds every 10 seconds |
| 3 | 3 minutter | Sound for 15 seconds every 5 seconds |
| 4 | 4 minutter | Sound for 20 seconds every 15 seconds |
Operation demonstrationsvideo
Opretholdelse
Udskiftning af batteri
When the low battery warning sounds (5 short beeps when the door is opened), it is time to replace the batteries.
- Slide the battery cover open on the main unit.
- Fjern de gamle AAA-batterier.
- Isæt to nye AAA-batterier, og sørg for at polariteten vender korrekt.
- Luk batteridækslet forsvarligt.
Rensning
To clean the device, gently wipe the exterior with a dry, soft cloth. Do not use liquid cleaners or immerse the device in water.
Fejlfinding
- Alarmen lyder ikke: Ensure the device is powered on (not in 'OFF' mode). Check if the batteries are correctly installed and have sufficient charge. Verify that the main unit and magnet are properly aligned and within the 0.98-inch (2.5 cm) gap.
- Alarm too quiet or too loud: Adjust the volume using the volume button on the side of the main unit.
- Falske alarmer: Re-check the alignment and gap between the main unit and the magnet. Ensure they are securely attached and not shifting.
- Advarsel om lavt batteri: Replace both AAA batteries with new ones.
Specifikationer
- Model: DA10
- Strømkilde: 2 x AAA batterier (medfølger)
- Voltage: 3 volt (DC)
- Kontrolmetode: Touch (for volume/mode), Slide Switch (for power/tone)
- Monteringstype: Door Mount (Adhesive)
- Sensorteknologi: Kontakt sensor
- Dimensioner (hovedenhed): Cirka 3.9 x 1.6 x 0.86 tommer (100 x 40 x 22 mm)
- Varens vægt: 7.2 ounce
- Lydniveau: 0-120 dB (Adjustable)
- Forsinkede tilstande: 1, 2, 3, 4 minutter
- Farve: Hvid
Garanti og support
For warranty information, technical support, or any inquiries regarding your DAYTECH DA10 Fridge and Freezer Door Alarm, please refer to the contact details provided on the product packaging or visit the official Daytech webwebsted. Behold din købskvittering som købsbevis i tilfælde af garantikrav.
