1. Introduktion
The Nerf Pro Gelfire Mythic Full Auto Blaster delivers high-performance blasting with hydrated rounds that burst on impact. Designed for ages 14 and up, this blaster features full-auto and semi-auto modes, a high-capacity 800-round hopper, and a convenient rechargeable battery. This manual will guide you through the setup, operation, and maintenance of your new Gelfire blaster to ensure a safe and enjoyable experience.
2. Vigtige sikkerhedsoplysninger
ADVARSEL: Der kan dannes små dele. Ikke egnet til børn under 3 år.
EYEWEAR REQUIRED: Always wear the included protective eyewear when using this blaster. Do not aim at eyes or face. Use only official Nerf Gelfire Rounds. Do not freeze or modify rounds. Do not modify blaster. Impact from rounds may cause temporary marks on skin. Adult supervision is recommended.
3. Hvad er der i æsken
- Nerf Pro Gelfire Mythic Blaster
- Genopladeligt 7.4V 500mAh LiPo-batteri
- Tragt med kapacitet på 800 patroner
- Removable Barrel Attachment
- 2 x 5,000-Round Packets of Dehydrated Nerf Pro Gelfire Soft Super Absorbent Polymer Projectiles (10,000 total)
- Beskyttelsesbriller
- Universal USB-A to USB-C Charging Cable (USB-A wall charger not included)
Figure 3.1: All included components of the Nerf Pro Gelfire Mythic Blaster.
4. Opsætning
4.1 Hydrating Gelfire Rounds
- Empty the dehydrated Nerf Pro Gelfire rounds into a large container.
- Add plenty of clean tap water to fully submerge the rounds.
- Allow the rounds to soak for 3 to 4 hours. They will expand significantly.
- Drain any excess water before use. The hydrated rounds are now ready for loading.
Figure 4.1: Gelfire rounds hydrating in water.
Figure 4.2: Dehydrated vs. Hydrated Gelfire Rounds.
4.2 Opladning af det genopladelige batteri
- Locate the rechargeable 7.4V 500mAh LiPo battery.
- Connect the battery to the included USB-A to USB-C charging cable.
- Plug the USB-A end of the cable into a compatible USB-A wall charger (not included).
- Allow the battery to charge for approximately 2 hours for a full charge. The indicator light on the battery will change to show charging status.
Figure 4.3: Rechargeable Battery.
4.3 Blaster Assembly
- Insert the charged rechargeable battery into the designated slot on the blaster. Ensure it clicks securely into place.
- Attach the extendable stock to the rear of the blaster by sliding it into position until it locks.
- Twist and attach the removable barrel to the front of the blaster.
- Ensure all attachments are firmly secured before use.
Figure 4.4: Assembled Nerf Pro Gelfire Mythic Blaster.
Video 4.1: Official demonstration of the Nerf Pro Gelfire Mythic Blaster, showing battery insertion, round hydration, and firing modes.
5. Betjening af blæseren
5.1 Isætning af beholderen
- Åbn låget på tragten med en kapacitet på 800 patroner.
- Carefully pour the hydrated Gelfire rounds into the hopper.
- Luk beholderlåget forsvarligt.
- Attach the filled hopper to the top rail of the blaster, ensuring it is locked in place.
Figure 5.1: Blaster with hopper attached.
5.2 Affyringstilstande
- Ensure your protective eyewear is on.
- Locate the power switch/mode selector on the blaster.
- Turn the blaster ON. The indicator light will illuminate.
- Select your desired firing mode:
- Semi-Auto Mode: Pull the trigger once for each round you wish to fire.
- Full-Auto Mode: Hold down the trigger for continuous blasting at up to 10 rounds per second.
- To activate the trigger lock, slide the orange safety switch located near the trigger. This prevents accidental firing.
Figure 5.2: Blaster trigger and mode selector.
6. Vedligeholdelse
6.1 Rengøring
Tør blasteren af med reklameamp cloth as needed. Do not submerge the blaster in water. Ensure no water enters the internal electronic components.
6.2 Storing Gelfire Rounds
Store hydrated Gelfire rounds in an airtight container away from direct sunlight and extreme temperatures to prevent them from drying out. If rounds dry out, they can be rehydrated by soaking them in water again.
7. Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Blaster not firing / Rounds getting stuck | Rounds not fully hydrated or jammed in the feeding mechanism. | Ensure rounds are fully hydrated (3-4 hours soak time). Gently shake the blaster to dislodge any stuck rounds. If the issue persists, remove the hopper and clear any visible obstructions. |
| Blaster tænder ikke | Batteriet er ikke opladet eller ikke isat korrekt. | Ensure the rechargeable battery is fully charged and correctly inserted into the blaster. Check the power switch is in the 'ON' position. |
| Lav skudhastighed | Batteriopladningen er lav. | Recharge the battery. Performance may decrease as the battery drains. |
8. Specifikationer
| Feature | Detalje |
|---|---|
| Modelnummer | F7267 |
| Mærke | Nerf |
| Dimensioner (L x B x H) | 14 x 2.62 x 10.5 tommer |
| Varens vægt | 1.5 pund |
| Beholderkapacitet | 800 runder |
| Rounds Included | 10,000 dehydrerede Gelfire-patroner |
| Batteritype | Rechargeable 7.4V 500mAh LiPo (included) |
| Ladekabel | USB-A to USB-C (included) |
| Anbefalet alder | 14 år og opefter |
| Affyringstilstande | Full-Auto, Semi-Auto |
| Maksimal skudhastighed | Up to 10 rounds per second (full-auto) |
| Materiale Type | Plast |
9. Garanti og support
For warranty information or product support, please contact Hasbro customer service directly. Refer to the packaging or Hasbro's official website for the most up-to-date contact details and warranty policies.
