Gravity Warzone WZ10D4-1 10-Inch Car Audio Shallow Subwoofer Instruction Manual

1. Introduktion

This manual provides comprehensive instructions for the installation, operation, and maintenance of your Gravity Warzone WZ10D4-1 10-inch car audio shallow subwoofers. Please read this manual thoroughly before installation and use to ensure proper function and longevity of your product. These subwoofers are designed for car audio applications, featuring a dual 4-ohm voice coil configuration for flexible wiring options.

Figure 1.1: Gravity Warzone WZ10D4-1 10-inch shallow subwoofer, showing the front cone and rear terminal connections.

2. Pakkens indhold

Kontroller, at alle dele er til stede i pakken, før du fortsætter installationen.

• 2x Gravity Warzone WZ10D4 Subwoofers

3. Sikkerhedsoplysninger

Overhold altid følgende sikkerhedsforanstaltninger under installation og drift:

• Frakobl køretøjets batteri, før du påbegynder elektrisk arbejde, for at undgå kortslutninger.
• Ensure proper ventilation for the subwoofer and ampfor at forhindre overophedning.
• Use appropriate gauge wiring for power, ground, and speaker connections to handle the current and power output.
• Avoid installing the subwoofer in locations where it may be exposed to moisture or extreme temperatures.
• Securely mount the subwoofer to prevent movement during vehicle operation, which could cause damage or injury.
• Prolonged exposure to high sound pressure levels can cause permanent hearing damage. Adjust volume levels responsibly.

4. Opsætning og installation

Proper installation is crucial for optimal performance and longevity of your subwoofers. If you are unsure about any part of the installation process, consult a professional car audio installer.

4.1 Krav til indkapsling

These subwoofers are designed for use in sealed or ported enclosures. Refer to the subwoofer's technical specifications for recommended enclosure volumes. Ensure the enclosure is robust and sealed properly to prevent air leaks.

4.2 Montering

Mount the subwoofer securely within the chosen enclosure using appropriate screws. Ensure there is no interference with the cone's movement and that the subwoofer gasket creates a tight seal with the enclosure.

4.3 Ledningsforbindelser

The WZ10D4-1 features a dual 4-ohm voice coil configuration. This allows for various wiring options to achieve different impedance loads at your amplifier. Common configurations include:

• 1 ohm belastning: Wire both voice coils in parallel.
• 2 ohm belastning: Wire each subwoofer's voice coils in series (8 ohms per sub), then wire the two subwoofers in parallel (4 ohms total). Or, wire each subwoofer's voice coils in parallel (2 ohms per sub), then wire the two subwoofers in series (4 ohms total). For a single subwoofer, wire the two 4-ohm voice coils in parallel to achieve a 2-ohm load.
• 8 ohm belastning: Wire both voice coils in series.

Always match the final impedance load to your amplifier's stable operating range. Incorrect wiring can damage your amplifier or subwoofers.

Figur 4.1: Nærbillede view of the subwoofer's push terminals for secure wire connections.

4.4 AmpLifier Valg

Vælg en amplifier that can provide sufficient RMS power within the recommended range for the WZ10D4-1 subwoofers (400 watts RMS each). Ensure the amplifier is stable at the impedance load presented by your wiring configuration.

5. Betjeningsvejledning

Once installed, operate your subwoofers by following these guidelines:

• Indledende opstart: After installation, turn on your car audio system at a low volume. Gradually increase the volume and check for proper operation and sound quality.
• Forstærkningsindstilling: Adjust the gain control on your amplifier carefully. Do not use the gain control as a volume knob. Set it to match the output voltage of your head unit to prevent distortion.
• Crossover-indstillinger: Brug lavpasfilteret (LPF) på din ampeller hovedenhed til kun at sende lave frekvenser til subwooferne. Et almindeligt udgangspunkt er 80-100 Hz.
• Indbrudsperiode: Allow a break-in period of approximately 20-30 hours of normal listening before operating the subwoofers at their maximum potential. This allows the suspension components to loosen up, improving performance.

6. Vedligeholdelse

Minimal maintenance is required for your subwoofers to ensure long-term performance:

• Rensning: Tør subwoofermembranen og -rammen regelmæssigt af med en blød, tør klud for at fjerne støv og snavs. Undgå at bruge skrappe kemikalier eller for meget fugt.
• Inspektion: Regularly inspect the wiring connections for tightness and corrosion. Check the subwoofer surround for any signs of damage or deterioration.
• Miljøfaktorer: Protect the subwoofers from direct sunlight, extreme temperatures, and moisture, which can degrade materials over time.

7. Fejlfinding

If you experience issues with your subwoofers, refer to the following common troubleshooting steps:

• Ingen lyd:
  • Check all power, ground, remote, and speaker connections for proper contact.
  • Bekræft amplifier is powered on (check power indicator light).
  • Ensure the head unit is sending an audio signal.
  • Check amplifier fuses and vehicle fuses.
• Forvrænget lyd:
  • Reducer amplifier forstærkning.
  • Check for proper crossover settings; ensure only low frequencies are sent to the subwoofer.
  • Verify the impedance load matches the amplifiers stabile driftsområde.
  • Ensure the subwoofer is not over-powered or under-powered.
• Svag bas:
  • Check amplifier gain and subwoofer level settings on the head unit.
  • Verify correct wiring polarity (+ to + and - to -).
  • Ensure the enclosure is sealed properly (if applicable) and of the correct volume.
  • Adjust crossover frequency and bass boost settings.

If problems persist after performing these checks, contact customer support or a qualified technician.

8. Specifikationer

9. Garantioplysninger

Gravity products are manufactured to high-quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Gravity webwebsted. Gem din købsbevis i tilfælde af garantikrav.

10. Support

For technical assistance, troubleshooting beyond this manual, or customer service inquiries, please contact Gravity customer support through their official webwebstedet eller de kontaktoplysninger, der er angivet med dit køb.