Indledning
This manual provides essential information for the safe and efficient use of your Teka TBC 64000 XFL Vitroceramic Hob. Please read all instructions carefully before installation and operation, and retain this manual for future reference.
Sikkerhedsoplysninger
Følg altid følgende sikkerhedsretningslinjer for at forhindre personskade eller beskadigelse af apparatet.
- Elektrisk sikkerhed: Ensure the hob is connected to a properly grounded electrical supply as specified in the technical data. Disconnect power before any maintenance or cleaning.
- Advarsel om varme: The hob surface and surrounding areas become hot during use. Exercise caution to avoid burns. Do not touch hot surfaces.
- Børnesikkerhed: Keep children away from the appliance during operation and while it is cooling down. The hob is not intended for use by persons with reduced physical, sensory, or mental capabilities unless supervised.
- Korrekt ventilation: Ensure adequate ventilation around the hob as per installation instructions to prevent overheating.
- Appropriate Cookware: Use only flat-bottomed cookware suitable for vitroceramic hobs. Overheating empty pans can cause damage.
- Rensning: Do not use abrasive cleaners or sharp objects that could scratch the glass surface. Clean only when the hob is cool.
Produkt overview
The Teka TBC 64000 XFL is a 60 cm vitroceramic hob featuring four cooking zones and ergonomic knob controls for precise temperature management.
The hob includes:
- Two High Light cooking zones with a diameter of 180 mm.
- Two High Light cooking zones with a diameter of 145 mm.
- Ergonomic control knobs for each zone.
- Residual heat indicators for safety.
Opsætning og installation
Installation should be performed by a qualified technician in accordance with local regulations and the provided instructions.
Udpakning
- Tag forsigtigt kogepladen ud af emballagen.
- Kontroller for eventuelle skader under transporten. Installer ikke, hvis beskadiget.
- Ensure all components are present, including the hob and any sealing gaskets.
Forberedelse af bordplade
The hob is designed for countertop installation. A precise cutout in the countertop is required. Refer to the dimensions diagram below for exact measurements.
- The hob dimensions are approximately 600mm (width) x 510mm (depth) x 57mm (height).
- The required cutout for installation is approximately 560mm (width) x 490mm (depth).
- Apply the provided sealing gasket around the edge of the hob before placing it into the cutout to ensure a secure and sealed fit.
Elektrisk tilslutning
- The hob requires a 240 Volt electrical supply.
- The maximum nominal power is 6000 Watts.
- Ensure the electrical circuit is capable of handling the hob's power requirements and is protected by an appropriate circuit breaker.
- The Fast-Click easy installation system simplifies securing the hob in place after electrical connection.
Operation
Your Teka vitroceramic hob is designed for intuitive cooking with precise control.
Turning On/Off a Cooking Zone
- Each cooking zone is controlled by a dedicated ergonomic knob located on the right side of the hob.
- To turn on a zone, rotate the corresponding knob clockwise to the desired heat setting. The hob will begin to heat up.
- To turn off a zone, rotate the knob counter-clockwise back to the '0' position.
Varmeindstillinger
The control knobs typically offer a range of heat settings from 1 (low) to 12 (high), allowing for fine-tuned temperature control for various cooking tasks.
Booster funktion
The hob is equipped with a Booster function for rapid heating. When activated, this function provides maximum power to a selected zone for a short period, quickly bringing liquids to a boil or heating pans. Refer to the specific markings on the control panel or knobs for Booster activation.
Restvarmeindikatorer
After a cooking zone is turned off, a residual heat indicator (often an 'H' symbol) will remain illuminated on the hob surface until the zone has cooled to a safe temperature. Do not touch the surface while the indicator is active.
Rengøring og vedligeholdelse
Regular cleaning and proper maintenance will ensure the longevity and optimal performance of your hob.
Daglig rengøring
- Sørg altid for, at kogepladen er afkølet, inden rengøring.
- Wipe the vitroceramic surface with a soft cloth or sponge and a mild detergent.
- For stubborn stains, use a specialized ceramic hob cleaner and a scraper designed for glass hobs.
- Rinse thoroughly with clean water and dry with a soft, clean cloth to prevent water marks.
Undgå skade
- Do not use abrasive sponges, scouring pads, or harsh chemical cleaners.
- Undgå at tabe tunge eller skarpe genstande på glasoverfladen.
- Skub ikke køkkengrej med ru bund hen over overfladen, da dette kan forårsage ridser.
- Clean up spills, especially sugary liquids, immediately after the hob cools to prevent them from hardening and causing damage.
Fejlfinding
Before contacting customer support, please consult the following common issues and solutions.
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Kogepladen tænder ikke. | Ingen strømforsyning. | Check the circuit breaker or fuse box. Ensure the hob is properly plugged in or wired. |
| Kogezonen varmer ikke op. | Incorrect knob setting or faulty element. | Ensure the knob is set to a heat level above '0'. If the problem persists, contact a qualified technician. |
| Residual heat indicator ('H') remains on for a long time. | Normal operation; hob is still hot. | This is a safety feature. Wait for the hob to cool down. |
| Usædvanlige lugte ved første brug. | Afbrænding af produktionsrester. | This is normal for new appliances. Ensure good ventilation. The odor will dissipate. |
If you encounter a problem not listed here or if the suggested solutions do not resolve the issue, please contact Teka customer support.
Tekniske specifikationer
| Feature | Specifikation |
|---|---|
| Mærke | Teka |
| Model | TBC 64000 XFL |
| Installationstype | Bordplade |
| Materiale Type | Vitroceramic (Glass Ceramic) |
| Farve | Sort |
| Varmeelementer | 4 (2 x Ø 180 mm, 2 x Ø 145 mm) |
| Kontroltype | Knop |
| Brændstoftype | Elektrisk |
| Voltage | 240 volt |
| Wattage | 6000 Watts (Maximum Nominal Power) |
| Produktmål (L x B x H) | 20.08 x 23.62 x 2.24 tommer (510 x 600 x 57 mm) |
| Varens vægt | 16.72 pund |
| Inkluderede komponenter | 1 x Teka TBC 64000 XFL Hob, Black Glass |
Garanti & Support
Producentens garanti
This Teka TBC 64000 XFL Vitroceramic Hob comes with a 1 års producentgarantiDenne garanti dækker materiale- og fabrikationsfejl ved normal brug. Gem venligst din købsbevis i tilfælde af garantikrav.
Kundesupport
For technical assistance, warranty service, or to order spare parts, please contact Teka customer support. Refer to the official Teka webwebstedet eller din købsdokumentation for kontaktoplysninger specifikke for din region.
