ProCom dobbelt brændstof uden ventilation gaspejs med kappe

Indledning

This manual provides detailed instructions for the safe installation, operation, and maintenance of your ProCom Dual Fuel Ventless Gas Fireplace System with Mantle. This system is designed to operate efficiently using either Natural Gas (NG) or Liquid Propane (LP) and features a thermostat control for consistent heating. Please read all instructions carefully before installation and use.

Billede: Forside view of the ProCom Dual Fuel Ventless Gas Fireplace System in Antique White, showcasing the mantle and the firebox with realistic logs and flames.

Sikkerhedsoplysninger

ADVARSEL: Forkert installation, justering, ændring, service eller vedligeholdelse kan forårsage personskade eller ejendomsskade. Se denne manual. For assistance eller yderligere information, kontakt en kvalificeret installatør, servicebureau eller gasleverandøren.

• Dette apparat er kun til indendørs brug.
• Opbevar eller brug ikke benzin eller andre brændbare dampe og væsker i nærheden af ​​dette eller noget andet apparat.
• På grund af høje temperaturer bør apparatet placeres uden for trafik og væk fra møbler og gardiner.
• Børn og voksne bør advares om farerne ved høje overfladetemperaturer og bør holde sig væk for at undgå forbrændinger eller antændelse af tøj.
• Små børn bør overvåges nøje, når de er i samme rum som apparatet.
• Anbring ikke tøj eller andet brændbart materiale på eller i nærheden af ​​apparatet.
• This appliance is equipped with an Oxygen Depletion Sensor (ODS) safety system. Do not attempt to bypass or tamper with the ODS.
• Ensure adequate ventilation as specified in the installation instructions.

Opsætning og installation

Udpakning og inspektion

Carefully remove all components from the packaging. Inspect for any shipping damage. If any damage is found, contact your retailer immediately. Ensure all parts listed in the "What's in the Box" section are present.

• Ventless Fireplace Insert - Qty. 1
• Ceramic Fiber Log Set - Qty. 1 (4 realistic hand painted Concrete Logs)
• Hardware Pack - Qty. 1
• Fireplace Mantel (Antique White Furniture Grade Finish) - Qty. 1

Forsamling

Some assembly is required for the mantle and the fireplace insert. Refer to the general assembly instructions provided with the product. Ensure the fireplace insert is securely placed within the mantle.

Image: The ProCom fireplace system integrated into a living room setting, demonstrating its aesthetic appeal.

Fuel Type Selection (Dual Fuel Technology)

This fireplace system is designed for use with either Natural Gas (NG) or Liquid Propane (LP). It is crucial to select the correct fuel type and ensure the appliance is configured accordingly before connecting to a gas supply.

Vigtig: Conversion between NG and LP must be performed by a qualified service technician. Incorrect conversion can lead to unsafe operation and void the warranty.

Image: Close-up of the gas inlet ports, labeled NG (Natural Gas) and LP (Liquid Propane), showing the blue cap for LP. This indicates the current configuration or the port for LP connection.

Image: Close-up of the gas inlet ports, labeled NG (Natural Gas) and LP (Liquid Propane), showing both yellow and blue caps. This illustrates the dual fuel capability and the distinct caps for each gas type.

Gasforbindelse

Connect the fireplace to the appropriate gas supply (Natural Gas or Liquid Propane) using approved gas connectors and fittings. Ensure all connections are tight and leak-free. A gas pressure test must be performed by a qualified technician.

• Maximum inlet gas pressure: 1/2 PSIG (3.5 kPa).

Betjeningsvejledning

Indledende opstart

1. Sørg for, at gasforsyningsventilen er åben.
2. Press and hold the control knob (refer to image below) to the "PILOT" position.
3. While holding the knob, press the Piezo ignitor button repeatedly until the pilot flame ignites.
4. Continue to hold the control knob for approximately 30-60 seconds after the pilot ignites to allow the thermocouple to heat up.
5. Slip betjeningsknappen. Hvis pilotflammen slukker, gentag trin 2-4.

Image: Close-up of the control panel showing the main control knob with settings for "OFF", "PILOT", and numbered temperature settings (1-5), alongside the Piezo ignitor button.

Thermostat Control Operation

Once the pilot is lit, turn the control knob to the desired temperature setting (1-5). The thermostat will automatically cycle the main burner on and off to maintain the set room temperature. Setting 1 is the lowest heat output, and setting 5 is the highest.

• 15,000 BTU Maximum Output: Heats up to 600 square feet.
• 99.9% Efficient: Provides economical supplemental heat.

Shutting Down the Fireplace

1. To turn off the main burner, turn the control knob to the "PILOT" position. The pilot flame will remain lit.
2. To completely turn off the fireplace, turn the control knob to the "OFF" position. This will extinguish both the main burner and the pilot flame.
3. For extended periods of non-use, it is recommended to close the main gas supply valve.

Opretholdelse

Generel rengøring

• Hold apparatets område klart og fri for brændbare materialer, benzin og andre brændbare dampe og væsker.
• Periodically clean the exterior surfaces of the mantle with a soft, damp klæde. Undgå slibende rengøringsmidler.
• Ensure the air openings of the appliance are not obstructed.

Log Set Care

The ceramic fiber logs are designed for durability. Handle them carefully to avoid breakage. Do not rearrange the logs from their factory-set positions, as this can affect flame appearance and efficiency.

Årlig eftersyn

It is recommended to have the fireplace inspected annually by a qualified service technician to ensure proper operation and safety.

Fejlfinding

If troubleshooting steps do not resolve the issue, contact a qualified service technician or ProCom customer support.

Specifikationer

Garantioplysninger

This ProCom Dual Fuel Ventless Gas Fireplace System is covered by a 1 års begrænset garanti. For specific terms and conditions, please refer to the warranty documentation included with your product or contact ProCom customer support.

Kundesupport

For technical assistance, parts, or warranty claims, please contact ProCom customer support. Have your model number (PCS150T-1-AW) and purchase date available when contacting support.

Fabrikant: ProCom

Refer to the product packaging or the official ProCom webhjemmeside for de seneste kontaktoplysninger.