Amewi 26070 Adventure RC Racing Katamaran Motorbåd Brugermanual

1. Introduktion

Tak for købetasing the Amewi 26070 Adventure RC Racing Catamaran Motor Boat. This manual provides essential information for the safe operation, setup, maintenance, and troubleshooting of your new remote-controlled boat. Please read this manual thoroughly before operating the boat to ensure proper function and to prevent damage or injury.

The Amewi 26070 is a high-performance racing catamaran designed for speed and maneuverability. It features a durable ABS hull, water-cooled motor, and a precise 2.4GHz radio system for sensitive control. This Ready-To-Run (RTR) model comes with most components pre-assembled, requiring minimal setup before use.

Figure 1: Amewi 26070 Adventure RC Racing Catamaran Motor Boat (Red)

This image displays the Amewi 26070 Adventure RC Racing Catamaran Motor Boat in its striking red color. The sleek design and "Adventure" branding are visible, highlighting its racing capabilities.

2. Sikkerhedsinstruktioner

Operating an RC boat requires attention to safety. Failure to follow these instructions may result in injury or damage to the product or property.

• Aldersanbefaling: Dette produkt anbefales til brugere fra 14 år. Voksenopsyn anbefales til yngre brugere.
• Kun til vandbrug: The boat is designed for use in water. Do not operate on land.
• Safe Operating Area: Operate the boat in open water areas, away from swimmers, wildlife, and other watercraft. Avoid areas with strong currents or obstacles.
• Batterisikkerhed:
  • Always use the specified Li-ion 7.4V 1800 mAh battery.
  • Undlad at overoplade eller overaflade batterier.
  • Efterlad aldrig opladningsbatterier uden opsyn.
  • Opbevar batterier et køligt, tørt sted, væk fra brandfarlige materialer.
  • If the battery becomes hot, swells, or shows any signs of damage, discontinue use immediately.
• Propeller Warning: Keep fingers, hair, and loose clothing away from the propeller when the boat is powered on. The propeller can cause serious injury.
• Vandindtrængen: While the boat is designed to be splash-proof, ensure all hatches are securely closed before operation to prevent water from entering the electronics compartment.
• Radiointerferens: Avoid operating near other RC devices or strong radio sources to prevent signal loss.
• Miljøforhold: Do not operate in extreme weather conditions, high winds, or during thunderstorms.

3. Pakkens indhold

Kontroller venligst pakkens indhold for at sikre, at alle varer er til stede:

• Amewi 26070 RC Racing Catamaran Motor Boat
• 2.4GHz Transmitter (Remote Control)
• Li-ion 7.4V 1800 mAh Battery (for boat)
• Batterioplader
• Bådestand
• Instruktionsmanual (dette dokument)
• Small tools/accessories (e.g., hex wrench, spare propeller - may vary)

4. Opsætning

4.1. Opladning af bådens batteri

1. Connect the Li-ion 7.4V 1800 mAh boat battery to the provided charger.
2. Sæt opladeren i en passende stikkontakt.
3. Allow approximately 120 minutes for a full charge. Refer to the charger's indicator lights for charging status.
4. Vigtig: Never leave the battery charging unattended. Disconnect the charger once charging is complete.

4.2. Installing Transmitter Batteries

The transmitter requires batteries (not included). Open the battery compartment on the back of the transmitter and insert the required batteries, observing correct polarity.

4.3. Installing the Boat Battery

1. Carefully open the top hatch of the boat.
2. Connect the fully charged Li-ion battery to the boat's power connector (Mini Tamiya connection).
3. Secure the battery within the compartment to prevent movement during operation.
4. Ensure all wires are clear of moving parts and the hatch seal.
5. Close the hatch securely to prevent water ingress.

Figure 2: Internal Motor Assembly

This image shows a close-up of the boat's internal motor assembly, highlighting the water-cooling jacket around the motor. Proper battery connection and wire routing are crucial in this area.

Figure 3: Internal Servo and Wiring

Dette billede giver en detaljeret view of the boat's steering servo and internal wiring connections. Ensure these components are securely mounted and connections are firm.

4.4. Transmitter Pairing

The 2.4GHz radio system typically pairs automatically. Turn on the transmitter first, then the boat. The boat's safety circuit ensures the propeller will not activate unless the boat is in water.

5. Betjeningsvejledning

5.1. Søsætning af båden

Place the boat gently into the water. The safety circuit will activate the motor only when the boat is submerged. Ensure the water is deep enough for the propeller and rudder to operate freely.

5.2. Styringer

• Gashåndtag: Use the throttle stick on the transmitter to control forward and reverse speed. The boat features a reverse gear for high maneuverability.
• Styretøj: Use the steering wheel/stick to control the rudder for left and right turns.
• Trimning: The transmitter allows for fine-tuning (trimming) of the rudder system to ensure the boat travels straight when the steering is centered. Adjust as needed for optimal performance.

Figure 4: Rudder and Propeller Assembly

Dette billede viser bagsiden view of the boat, detailing the rudder and propeller assembly. The precise control of these components is essential for steering and propulsion.

5.3. Køretips

• Start med lave hastigheder for at vænne dig til betjeningen.
• The catamaran design provides excellent stability in curves.
• Be mindful of the boat's range (approximately 80 meters) to avoid losing control.
• The typical driving time is about 20 minutes. Monitor the boat's speed and responsiveness as the battery depletes.
• If the boat loses power or signal, retrieve it manually.

6. Vedligeholdelse

Regular maintenance ensures the longevity and performance of your RC boat.

• Efter hver brug:
  • Remove the boat battery.
  • Drain any accumulated water from the hull. The boat features a drainage system (see Figure 5).
  • Wipe down the boat with a soft, dry cloth.
  • Inspect the propeller, rudder, and all moving parts for debris or damage.
• Vandkølesystem: The motor is water-cooled. Ensure the water intake and outlet are clear of obstructions.
• Batteriopbevaring: Store the Li-ion battery in a cool, dry place at a storage charge (around 3.8V per cell) if not used for extended periods. Do not store fully charged or fully discharged.
• Sender: Remove batteries from the transmitter if it will not be used for a long time.

Figure 5: Water Drainage System

This image illustrates the water drainage point at the rear of the boat, indicating how water can be expelled from the hull after use. Ensure this drain is clear.

7. Fejlfinding

8. Specifikationer

9. Garanti og support

Amewi products are manufactured to high-quality standards. For warranty information, technical support, or spare parts, please contact your retailer or the official Amewi customer service. Please retain your proof of purchase for any warranty claims.

For further assistance, please visit the official Amewi webwebstedet eller kontakt deres supportkanaler direkte.