Indledning
This instruction manual provides detailed guidance for the safe and proper installation, operation, and maintenance of your Rocketfish Tilting TV Wall Mount. This mount is designed to securely hold flat-panel TVs ranging from 32 to 90 inches, with a maximum weight capacity of 130 lbs. Please read this manual thoroughly before beginning installation.
Vigtige sikkerhedsoplysninger
ADVARSEL: Failure to read and follow these instructions may result in serious personal injury, property damage, or voiding of your warranty. If you do not understand these instructions or have doubts about the safety of the installation, contact customer support or a qualified installer.
- Do not install this product if you cannot understand the installation instructions.
- Sørg for, at monteringsfladen sikkert kan bære den samlede vægt af beslaget og tv'et.
- Use only the provided hardware. Do not use the mount for any purpose not expressly specified by the manufacturer.
- Dette produkt er kun beregnet til indendørs brug.
- Always ensure the TV is securely attached to the mount before releasing det.
Pakkens indhold
Verify that all components are present and undamaged. If any parts are missing or damaged, do not attempt to install the mount. Contact Rocketfish customer service for assistance.
- Vægplademontering
- Tv-beslag (2)
- Monteringssæt (forskellige skruer, skiver, afstandsstykker, ankre)
- Instruktionsmanual (dette dokument)
Image: Main components of the Rocketfish Tilting TV Wall Mount, including the wall plate and two TV brackets.
Billede: Demonteret view of the Rocketfish Tilting TV Wall Mount, showing the wall plate and the two vertical TV mounting arms.
Opsætning og installation
Proper installation is crucial for the safety and performance of your TV mount. It is highly recommended to have at least two people for installation.
Nødvendige værktøjer (ikke inkluderet):
- Stud Finder
- Bore
- Niveau
- Phillips hovedskruetrækker
- Blyant
- Målebånd
Trin-for-trin installation:
- Forbered tv'et: Lay your TV face down on a soft, clean surface. Attach the two TV brackets to the back of your TV using the appropriate screws and spacers from the hardware kit. Ensure the brackets are centered and securely fastened to the VESA mounting holes.
- Find vægstolper: Use a stud finder to locate the center of two adjacent wooden studs in your desired mounting location. Mark these locations with a pencil. For concrete or brick walls, use appropriate anchors (not always included, check hardware kit).
- Position the Wall Plate: Hold the wall plate against the wall, aligning the mounting holes with the marked stud centers. Use a level to ensure the wall plate is perfectly horizontal. Mark the drill hole locations.
- Bor pilothuller: Drill pilot holes at the marked locations. The size of the drill bit will depend on the type of wall and the lag bolts being used. Refer to the hardware kit instructions for specific drill bit sizes.
- Fastgør vægplade: Secure the wall plate to the wall using the lag bolts and washers. Tighten all bolts firmly, but do not overtighten.
- Hæng fjernsynet op: With assistance, carefully lift the TV and hook the TV brackets onto the top edge of the wall plate. Gently lower the TV until the brackets engage with the wall plate.
- Fastgør tv'et: Locate the safety screws or locking mechanisms on the bottom of the TV brackets. Tighten these to secure the TV to the wall plate and prevent accidental dislodgement.
Operating the Tilting Feature
The Rocketfish Tilting TV Wall Mount allows for easy adjustment of your TV's vertical viewvinkel.
- To tilt the TV, gently push or pull the bottom edge of the TV to achieve the desired angle. The mount is designed for smooth, fingertip tilt action.
- The maximum tilt angle is approximately 10 degrees.
- Ensure all cables are clear and not pinched when adjusting the tilt.
Opretholdelse
Regelmæssig vedligeholdelse sikrer dit TV-beslags levetid og sikker drift.
- Rensning: Tør holderen af med en blød, tør klud. Brug ikke slibende rengøringsmidler eller opløsningsmidler.
- Periodiske kontroller: Periodically check all screws and bolts to ensure they remain tight. Over time, vibrations or adjustments can cause fasteners to loosen.
- Vægtgrænse: Never exceed the maximum weight capacity of 130 lbs (58.9 kg).
Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| TV'et er ikke i vater. | Vægpladen er ikke i vater under installationen. | Remove TV, loosen wall plate bolts, adjust with a level, and re-tighten. |
| Difficulty plugging in cables after mounting. | Limited space between TV and wall. | It is recommended to connect all necessary cables to the TV before mounting. If already mounted, carefully tilt the TV to access ports or consider using right-angle adapters. |
| Bjerget føles ustabilt. | Loose fasteners or improper installation. | Immediately remove TV. Re-check all mounting points and fasteners for tightness. Ensure installation followed instructions for wall type. |
| TV does not tilt smoothly. | Mechanism might be stiff or obstructed. | Check for any obstructions behind the TV. Ensure the tilt mechanism is clean and free of debris. |
Specifikationer
- Model: RF-TVMLPT03
- Produktdimensioner: 1.9 x 28.5 x 17.5 tommer
- Varens vægt: 6 pund
- Materiale: Metal
- Monteringstype: Vægmontering
- Bevægelsestype: Tilt
- Minimum Compatible TV Size: 32 tommer
- Maximum Compatible TV Size: 90 tommer
- Maksimal vægtkapacitet: Op til 130 lbs (58.9 kg)
- Maksimal hældningsvinkel: 10 grader
- Farve: Sort
Garanti og support
For warranty information or technical support, please refer to the official Rocketfish webwebstedet eller kontakt deres kundeserviceafdeling. Gem din købskvittering til garantikrav.
Juridisk ansvarsfraskrivelse: Up to 130 lbs. for sturdy support. (Product packaging may indicate compatibility with 32" - 56" flat-panel TVs.)
