Genie Garageportåbner-controller 39165R brugermanual

Indledning

This manual provides detailed instructions for the installation, operation, and maintenance of your Genie Garage Door Opener Controller, model 39165R. This controller is compatible with Genie garage door openers that use models 34026A-R1, Series II, and 37351R. Please read this manual thoroughly before use to ensure proper function and safety.

Genie Garage Door Opener Controller 39165R

A gray Genie garage door opener controller with a white faceplate, featuring a large primary button, lock/unlock icons, and a light bulb icon. The Genie logo is prominently displayed in red.

Vigtige sikkerhedsinstruktioner

Always keep the remote controls out of reach of children.
Lad ikke børn betjene garageportåbneren.
Ensure the garage door is visible and clear of obstructions before operating.
Regularly inspect the garage door system for proper balance and operation.

Opsætning og installation

Programming Your Controller

This section outlines the steps to program your new Genie Garage Door Opener Controller 39165R to your existing Genie garage door opener.

Step 1: Locate the Learn Button

The "Learn" button is typically found on the motor head of your garage door opener. Its color may vary (e.g., red, purple, orange, green). Refer to your specific garage door opener's manual if you cannot locate it.

Step 2: Initiate Programming

Press and immediately release the "Learn" button on your garage door opener motor head. The LED indicator light next to the button will illuminate.
Within 30 seconds, press and hold the desired button on your new 39165R controller for approximately 2 seconds.
Release the button. The garage door opener's light will flash once, or you may hear a click, indicating successful programming.

Step 3: Test the Controller

Press the programmed button on your 39165R controller. The garage door should activate. If it does not, repeat the programming steps.

Betjeningsvejledning

Your 39165R controller features buttons for opening/closing the garage door and controlling the opener's light.

Garage Door Operation: Press the large primary button to open or close the garage door. Pressing it again during operation will stop the door.
Lysstyring: Press the button with the light bulb icon to turn the garage door opener's light on or off, independent of door movement.
Lock Feature (if applicable): Some models may have a lock button (represented by padlock icons). Consult your opener's manual for specific functionality.

Opretholdelse

Udskiftning af batteri

The 39165R controller uses a standard coin cell battery (e.g., CR2032). When the range decreases or the LED indicator on the controller fails to light up, it's time to replace the battery.

Locate the small screw or tab on the back or side of the controller casing.
Use a small screwdriver or coin to open the casing.
Carefully remove the old battery. Note its orientation (+/-).
Indsæt det nye batteri med den korrekte polaritet.
Luk casing sikkert.

Rensning

Wipe the controller with a soft, dry cloth. Avoid using harsh chemicals or abrasive cleaners.

Fejlfinding

Fælles problemer og løsninger

Controller virker ikke:
- Tjek batteri: Replace the battery if it's low or dead.
- Omprogrammer: The controller may have lost its programming. Follow the "Setup and Installation" steps to reprogram it.
- Områdeproblemer: Ensure there are no obstructions between the controller and the garage door opener. Check for interference from other electronic devices.
Garage Door Not Responding:
- Strømforsyning: Verify the garage door opener has power.
- Sikkerhedssensorer: Check if the safety sensors are aligned and free of obstructions.
- Manual Disconnect: Ensure the emergency release cord has not been pulled, disconnecting the door from the opener.

If problems persist after attempting these solutions, consult a qualified garage door technician.

Specifikationer

Produktspecifikationer

Model: 39165R
Kompatibilitet: Genie garage door openers compatible with models 34026A-R1, Series II, 37351R.
Strømkilde: Battery (e.g., CR2032, not included)
Dimensioner: Cirka 5 x 3 x 1.4 cm (pakkemål)
Vægt: Cirka 7.2 ounces (varevægt)
Fabrikant: Generic (functions as a Genie compatible part)

	Genie Garage Door Opener Programming Guide: Residential & Commercial Models Comprehensive guide for programming Genie residential and commercial garage door openers, including models from 1995 to current production. Learn how to program remotes, change batteries, and troubleshoot common issues. Covers various programming button pad types and safety warnings.
	Genie trådløst tastatur Intellicode programmerings- og betjeningsvejledning Omfattende vejledning til trådløse Genie Intellicode-tastaturpaneler, der dækker programmering, betjening, montering, batteriudskiftning og fejlfinding. Indeholder sikkerhedsadvarsler og lovgivningsmæssige oplysninger.
	Brugsanvisning til Genie GK-R trådløst tastatur Dette dokument indeholder instruktioner til programmering og betjening af Genie GK-R trådløst tastatur til garageportåbnere. Det dækker opsætning af PIN-kode, programmering til enkelt- og flerdøre, betjening af tastatur, montering, udskiftning af batteri og nulstilling af tastaturet til fabriksindstillingerne.
	Guide til udskiftning af motor til Genie garageportåbner Trinvise instruktioner til udskiftning af motoren i en Genie garageportåbner, inklusive sikkerhedsforanstaltninger og detaljerede diagrambeskrivelser.
	Genie-styrerhjulsudskiftningsvejledning Trinvise instruktioner til udskiftning af remskiven på en Genie garageportåbner. Indeholder advarsler, nødvendige værktøjer og detaljerede procedurer for sikker og effektiv reparation.
	Sådan skifter eller udskifter du dit Genie trådløse tastaturdæksel Trinvise instruktioner til udskiftning eller udskiftning af dækslet på dit trådløse Genie-tastatur. Lær, hvordan du sikkert fjerner det gamle dæksel og monterer det nye, med denne vejledning.

Genie 39165R