Indledning
This manual provides detailed instructions for the installation, operation, and maintenance of your Project Source Chrome 1-Handle Pull-Down Kitchen Faucet, model 51-K814-PS-CP. Please read this manual thoroughly before beginning installation and retain it for future reference.
Sikkerhedsoplysninger
- Sluk altid for hovedvandforsyningen, inden du installerer eller vedligeholder vandhanen.
- Wear safety glasses and gloves during installation to prevent injury.
- Sørg for, at alle forbindelser er sikre for at forhindre lækager.
- Hvis du er usikker på nogen del af installationsprocessen, skal du kontakte en kvalificeret VVS-installatør.
Pakkens indhold
Kontroller, at alle komponenter er til stede, før installationen påbegyndes:
Figur 1: All components of the Project Source pull-down kitchen faucet, including the main faucet body, hot and cold water supply lines, mounting hardware, deck plate, and instruction manual.
- Hovedarmaturhus med nedtrækkelig sprøjte
- Hot and Cold Water Supply Lines (pre-attached)
- Monteringsudstyr (møtrik, skive, pakning)
- Deck Plate (optional, for 3-hole sinks)
- Weight (for pull-down hose)
- Instruktionsmanual
Opsætning og installation
Nødvendige værktøjer:
- Justerbar skruenøgle
- Phillips hovedskruetrækker
- VVS-kit eller silikoneforsegling
- Spand (til at opsamle dryp)
- Lommelygte
Installationstrin:
- Klargør vasken: Turn off the hot and cold water supply valves under the sink. Open the existing faucet to drain any remaining water. Disconnect and remove the old faucet. Clean the sink surface thoroughly.
- Installer dækplade (valgfrit): If your sink has three holes, place the deck plate (if using) over the sink holes. Apply a thin bead of plumber's putty or silicone sealant around the underside edge of the deck plate to create a watertight seal.
- Monter vandhanen: Insert the faucet body through the center hole of the sink (and deck plate, if used). From underneath the sink, slide the rubber washer, then the metal washer, and finally thread the mounting nut onto the faucet shank. Hand-tighten, then use an adjustable wrench to secure it firmly, ensuring the faucet is properly aligned.
- Tilslut vandforsyningsledninger: Connect the hot and cold water supply lines from the faucet to the corresponding hot and cold water supply valves. The faucet's lines are typically labeled (e.g., "HOT" for hot water). Hand-tighten, then use an adjustable wrench for a final quarter-turn. Do not overtighten.
- Install Hose Weight: Locate the indicator on the pull-down hose (usually a sticker or mark) where the weight should be installed. Attach the provided weight to the pull-down hose at this indicated position. This weight helps the sprayer retract smoothly.
- Tjek for lækager: Slowly turn on the hot and cold water supply valves. Check all connections for leaks. If leaks are present, tighten the connections slightly until the leak stops.
- Skyl vandhanen: Remove the sprayer head and turn on the faucet to flush out any debris from the lines. Let the water run for a few minutes. Turn off the faucet, reattach the sprayer head, and check for proper operation.
Betjeningsvejledning
- Vandgennemstrømning og temperatur: Det enkelte håndtag styrer både vandgennemstrømning og temperatur. Løft håndtaget for at øge vandgennemstrømningen. Flyt håndtaget til venstre for varmt vand og til højre for koldt vand.
- Nedtrækkelig sprøjte: Grasp the sprayer head and pull it down from the spout. The hose will extend to allow for greater reach. Press the button on the sprayer head to switch between stream and spray functions. When finished, guide the sprayer head back into the spout; the hose weight will assist in retraction.
Opretholdelse
- Rensning: Clean the faucet regularly with a soft cloth and mild soap. Avoid abrasive cleaners, harsh chemicals, or scouring pads, as these can damage the chrome finish.
- Rengøring af belufteren: If water flow decreases, the aerator may be clogged. Unscrew the aerator from the tip of the sprayer head, clean any debris, and rinse thoroughly before reattaching.
- Hose Weight Adjustment: If the pull-down sprayer does not retract smoothly, check the position of the hose weight. Adjust its position along the hose as needed to ensure proper retraction.
Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Lav vandgennemstrømning | Clogged aerator; partially closed supply valves. | Clean aerator; fully open supply valves. |
| Lækager ved forbindelser | Løse forbindelser; beskadigede skiver. | Tighten connections; replace washers if damaged. |
| Sprøjten trækker sig ikke tilbage | Hose weight is misplaced or missing; obstruction. | Adjust or reattach hose weight; clear any obstructions. |
| Dryppende vandhane | Slidt patron. | Contact customer support for cartridge replacement. |
Specifikationer
| Feature | Detalje |
|---|---|
| Modelnummer | 51-K814-PS-CP |
| Mærke | Projektkilde |
| Farve | Chrome |
| Stil | Nutidige |
| Slutte | Poleret |
| Materiale | Keramik (til patron) |
| Installationsmetode | Enkelt hul |
| Flowhastighed | 1.8 gallon pr. Minut |
| Antal håndtag | 1 |
| Monteringstype | Dækmontering |
| Særlige funktioner | Træk ned sprøjte |
| Produktdimensioner | 27.43 x 8.64 x 64.52 cm |
| Varens vægt | 2.34 kg |
Garanti og support
For warranty information or technical support, please refer to the contact details provided with your purchase documentation or visit the official Project Source webwebsted. Behold din købskvittering som købsbevis i tilfælde af garantikrav.
