Indledning
The Husky 500-Lumen Dual Beam Unbreakable Aluminum Flashlight (Model 16FL1111) is engineered for durability and versatile illumination. Featuring high-power LED and COB (Chip-on-Board) technology, it provides both focused spot lighting and wide-range flood lighting. This flashlight is designed to withstand drops from up to 30 feet and is waterproof to 1 meter, making it suitable for demanding environments. It offers three distinct operating modes: spot, flood, and a combination of both. An Energizer Alkaline battery is included, providing up to 500 lumens of bright light.
Figure 1: The Husky 500-Lumen Dual Beam Unbreakable Aluminum Flashlight.
Sikkerhedsoplysninger
- Batterisikkerhed: Always insert batteries with correct polarity (+ and -). Do not mix old and new batteries, or different types of batteries. Remove batteries if the flashlight will not be used for an extended period to prevent leakage. Dispose of used batteries responsibly.
- Øjenbeskyttelse: Do not shine the flashlight directly into eyes, as the high-intensity light can cause temporary vision impairment or damage.
- Advarsel om varme: The flashlight head may become warm during prolonged use. Handle with care.
- Vandtæt vurdering: While waterproof to 1 meter, ensure the battery cap is securely tightened before exposing to water. This rating does not imply suitability for diving or prolonged submersion.
- Børn: Holde utilgængeligt for børn. Dette er ikke et legetøj.
Pakkens indhold
Bekræft at alle varer er til stede i pakken:
- Husky 500-Lumen Dual Beam Unbreakable Aluminum Flashlight (Model 16FL1111)
- Energizer Alkaline Batteries (4 AA batteries required, included)
Opsætning
Installation af batteri
- Skru bagkappen af: Locate the tail cap of the flashlight (the end with the power button). Rotate the tail cap counter-clockwise until it detaches from the flashlight body.
- Indsæt batterier: Insert four (4) AA Energizer Alkaline batteries into the battery compartment. Ensure the positive (+) and negative (-) ends of the batteries align with the polarity indicators inside the compartment.
- Sikker bagkappe: Carefully screw the tail cap back onto the flashlight body by rotating it clockwise. Tighten firmly to ensure a secure connection and maintain the waterproof seal.
Figure 2: The tail cap with the power button, where batteries are inserted.
Betjeningsvejledning
The Husky 500-Lumen Flashlight features a single power button located on the tail cap to control power and switch between lighting modes.
Tænd/sluk
- At tænde lommelygten ON, tryk én gang på tænd/sluk-knappen.
- At tænde lommelygten SLUKKET, press and hold the power button for approximately 2 seconds from any mode.
Ændring af belysningstilstande
Once the flashlight is on, short press the power button repeatedly to cycle through the available lighting modes:
- Spot Beam: Provides a focused, narrow beam for long-distance illumination.
- Oversvømmelsesstråle: Provides a wide, diffused beam for area lighting.
- Dual Beam (Spot + Flood): Combines both beams for maximum illumination and coverage.
Figure 3: The flashlight head with its dual LED light sources for spot and flood beams.
Figure 4: The flashlight in use, demonstrating its illumination capability on a workbench.
Figure 5: The flashlight providing light for detailed inspection of an electrical panel.
Opretholdelse
- Rensning: Tør lommelygtens hus af med en blød kludamp klæde. Brug ikke slibende rengøringsmidler eller opløsningsmidler.
- Udskiftning af batteri: Replace all four AA batteries when the light dims significantly. Refer to the "Battery Installation" section for proper replacement.
- Opbevaring: Store the flashlight in a cool, dry place away from direct sunlight. If storing for an extended period, remove the batteries to prevent leakage and corrosion.
- O-ringe: Periodically inspect the O-rings on the tail cap for any signs of wear or damage. A thin layer of silicone grease can be applied to maintain the waterproof seal.
Figure 6: The flashlight standing upright on a workbench, ready for use or storage.
Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Lommelygten tænder ikke. |
|
|
| Lyset er svagt eller flimrer. |
|
|
| Vand inde i lommelygten. |
|
|
Specifikationer
| Modelnummer | 16FL1111 |
| Lyskildetype | LED |
| Lysstyrke | 500 lumen |
| Materiale | Aluminium |
| Strømkilde | Batteridrevet |
| Batteritype | 4 x AA Alkaline (Included) |
| Driftstilstande | Spot, Flood, Dual Beam |
| Faldtestvurdering | 30 fod. |
| Vandtæt vurdering | 1 m |
| Produktdimensioner | 30.48 x 12.98 x 6.35 cm |
| Varens vægt | 408.23 g (0.9 pund) |
Garanti og support
For warranty information or technical support regarding your Husky 500-Lumen Dual Beam Unbreakable Aluminum Flashlight, please refer to the warranty card included with your purchase or visit the official Husky Tools website. Please note that international products may have separate terms and conditions regarding warranty and support.
Figure 7: The Husky flashlight positioned near a tool belt, indicating its utility for professionals and DIY enthusiasts.
