1. Vigtige sikkerhedsoplysninger
Læs alle instruktioner, før du installerer eller bruger denne varmeovn. Manglende overholdelse af disse instruktioner kan resultere i brand, elektrisk stød, alvorlig personskade eller død.
- Elektrisk beskyttelse: Protect the unit with appropriate circuit breakers or fuses as per the nameplate specifications.
- Voltage Kompatibilitet: Sørg for, at forsyningen voltage (volts) matches the rating indicated on the heater's nameplate.
- Jording: Denne enhed skal være korrekt jordet.
- Ledningsføring: Use copper conductors only. Power leads must be suitable for 75°C (167°F).
- Strømafbrydelse: Always switch off the power supply to the unit at the circuit breaker/fuse before any installation, repair, or cleaning.
- Tiltænkt brug: Verify that the heater is suitable for its intended application. Consult the product catalog or a representative if unsure.
- Anbefalet varmekapacitet: For optimal performance, a heating capacity of 1.25 W per cubic foot (0.03 m³) is recommended.
2. Produktet er slutview
The Uniwatt by Stelpro UHC1002W is a modern, surface-mounted convector heater designed for quiet and efficient heating. It features a durable 22-gauge steel cabinet and an integrated electronic thermostat for precise temperature control.
Front view of the Uniwatt by Stelpro UHC1002W Convector Heater.
Side view illustrerer den slanke profile of the convector heater.
Detail of the effective heating elements: two stainless steel tubular sheathed elements isolated with nylon sleeves to reduce expansion and contraction noises.
The heater's design promotes efficient airflow, drawing cool air from below and expelling warm air through the front grille, creating a chimney effect for consistent heat distribution.
3. Installationsvejledning
This heater is designed for surface or wall-mounted installation. Ensure power is disconnected at the circuit breaker before beginning installation.
3.1 Montering
- The heater must be mounted with a minimum clearance of 4 inches (10 cm) from the floor.
- Utilize the concealed mounting bracket for a secure and tidy installation.
Image illustrating the concealed mounting bracket for wall installation.
3.2 Elektrisk tilslutning
- The heater requires a 240V hardwired connection.
- Use the back entry plate with cable clamps for a secure and organized wiring setup within the junction box.
- All wiring must comply with local electrical codes and regulations.
Diagram showing a typical 240V hardwired connection within a junction box.
4. Betjeningsvejledning
The Uniwatt UHC1002W heater features a built-in electronic thermostat for precise temperature control and energy optimization.
4.1 Indstilling af temperaturen
- Use the control buttons adjacent to the digital display to adjust the desired room temperature.
- The electronic thermostat will maintain the set temperature, cycling the heater on and off as needed.
Nærbillede view of the integrated electronic thermostat display and control buttons.
5. Vedligeholdelse
Regular maintenance ensures optimal performance and longevity of your heater. Always disconnect power at the circuit breaker before performing any maintenance.
5.1 Rengøring
- Rengør ydersiden af varmeren med en blød, damp klæde. Brug ikke slibende rengøringsmidler eller opløsningsmidler.
- Ensure the air intake and exhaust grilles are free from dust and debris to maintain proper airflow.
6. Fejlfinding
If you experience issues with your Uniwatt convector heater, consult the following table for common problems and solutions.
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Varmeapparatet tænder ikke | No power supply; Circuit breaker tripped; Thermostat set too low | Check circuit breaker; Ensure power is on; Increase thermostat setting |
| Utilstrækkelig opvarmning | Thermostat set too low; Obstruction of air grilles; Heater size inadequate for room | Increase thermostat setting; Clear grilles; Refer to heating capacity guidelines |
| Usædvanlige lyde | Dust or debris inside unit; Loose mounting | Disconnect power and inspect/clean; Ensure heater is securely mounted |
Hvis problemet fortsætter efter at have forsøgt disse løsninger, skal du kontakte kundesupport.
7. Specifikationer
| Feature | Detalje |
|---|---|
| Mærke | Stelpro (Uniwatt) |
| Modelnummer | UHC1002W |
| Strøm/Wattage | 1000 watt |
| Voltage | 240 volt |
| Materiale | 22-gauge Steel |
| Farve | Hvid |
| Produktdimensioner | 58.1 x 10 x 44.61 cm (22 7/8" W x 3 7/32" D x 17 9/16" H) |
| Varens vægt | 6.03 kg |
| Særlige funktioner | Built-in Electronic Thermostat |
| Monteringstype | Vægmontering (overflade) |
| Indendørs/Udendørs brug | Indendørs |
| Opvarmningsmetode | Konvektion |
Dimensional diagram of the Uniwatt convector heater.
Indication that the product is proudly made in Canada.
8. Garanti og support
8.1 Garanti
This Uniwatt by Stelpro convector heater comes with a 2 års garanti from the date of purchase, covering defects in material and workmanship under normal use.
8.2 Kundesupport
For technical assistance, warranty claims, or any questions regarding your heater, please contact Stelpro customer service:
- Telefon: 1-844-783-5776
- E-mail: info@stelpro.com
- Adresse: 1041 Rue Parent, Saint-Bruno-de-Montarville, QC J3V 6L7
