Møn T3292

Moen T3292 Align Moentrol Volume Control Modern Shower Trim Kit Brugsanvisning

Model: T3292 | Brand: Moen

1. Introduktion

This manual provides detailed instructions for the installation, operation, and maintenance of your Moen T3292 Align Moentrol Volume Control Modern Shower Trim Kit. This trim kit is designed to work with the Moentrol valve system, which balances water pressure to maintain temperature stability. It is also compatible with the Moen M-PACT common valve system, allowing for future style updates without plumbing changes.

2. Vigtige sikkerhedsoplysninger

  • Always shut off the main water supply before beginning any installation or maintenance.
  • Hvis du er usikker på nogen del af installationsprocessen, anbefales det at konsultere en kvalificeret professionel VVS-installatør.
  • Brug passende personlige værnemidler, såsom sikkerhedsbriller, under installationen.
  • Sørg for, at alle forbindelser er sikre og vandtætte for at forhindre lækager.

3. Pakkens indhold

Your Moen T3292 Align Moentrol Volume Control Modern Shower Trim Kit includes the following components:

  • Brusehoved
  • Brusearm
  • Escutcheon (wall plate)
  • Håndtagssamling

Note: The Moentrol valve (#3510, 3520, or 3570) is required for installation and is sold separately. This trim kit cannot function without the correct valve.

Image of a brass Moentrol valve, labeled 'REQUIRED VALVE SOLD SEPARATELY'

Figure 1: Moentrol Valve (Sold Separately)

4. Installationsvejledning

This section outlines the general steps for installing the Moen T3292 Trim Kit. For detailed valve installation, refer to the specific Moentrol valve instruction manual (models #3510, 3520, or 3570).

4.1. Forinstallation

  1. Ensure the correct Moentrol valve is already installed in the wall according to its specific instructions.
  2. Verify that the valve rough-in depth is appropriate for the trim kit. Improper depth can cause the handle to protrude excessively.
  3. Shut off the main water supply to the shower area.

4.2. Installation af trimsættet

  1. Installer brusearm: Apply plumber's tape to the threaded end of the shower arm. Thread the shower arm into the wall fitting until hand-tight, then tighten with a wrench, ensuring the arm is positioned correctly.
  2. Install Showerhead: Thread the showerhead onto the shower arm. Hand-tighten, then use a wrench to secure, being careful not to overtighten.
  3. Install Escutcheon: Place the escutcheon (wall plate) over the valve body, aligning it with the mounting holes. Secure it with the provided screws.
  4. Install Handle Assembly: Follow the specific instructions provided with your Moentrol valve for installing the handle. This typically involves attaching the handle to the valve stem and securing it with a set screw.
Image of the Moen T3292 Align Moentrol Shower Trim Kit in chrome, showing the showerhead, shower arm, and control handle.

Figure 2: Moen T3292 Trim Kit Components

Image of an installed Moen shower system with a showerhead and a separate handheld shower, showcasing the trim kit in a modern bathroom setting.

Figur 3: Eksample of an Installed Moen Shower System

5. Betjeningsvejledning

The Moen T3292 Align Moentrol Shower Trim Kit provides precise control over water volume and temperature.

5.1. Lydstyrkekontrol

The handle controls the water flow. Rotate the handle to increase or decrease the water volume from a gentle stream to full force. This allows for water conservation when full flow is not required.

5.2. Temperaturkontrol

The Moentrol valve features pressure balancing technology, which helps maintain your desired water temperature even when other water sources in the house are in use. To adjust the temperature, rotate the handle to the desired position. The valve includes an integrated temperature limit stop for safety, which can be adjusted during valve installation to prevent scalding.

Diagram illustrating the 'How to Use' and 'Benefits' of the Moentrol Valve, showing volume control, temperature memory, pressure balancing, and temperature limit stop.

Figure 4: Moentrol Valve Usage and Benefits

6. Vedligeholdelse og pleje

To maintain the chrome finish and ensure optimal performance of your Moen shower trim kit, follow these care guidelines:

  • Rengør regelmæssigt med en blød klud og mild sæbe eller et ikke-slibende rengøringsmiddel, der er specielt designet til kromoverflader.
  • Undgå at bruge slibende rengøringsmidler, skrappe kemikalier eller skuresvampe, da disse kan beskadige overfladen.
  • Skyl grundigt med rent vand efter rengøring og tør af for at undgå vandpletter.
  • Periodically check the showerhead for mineral buildup. If necessary, clean the nozzles by gently rubbing them or soaking the showerhead in a vinegar solution.

7. Fejlfinding

If you encounter issues with your Moen T3292 shower trim kit, refer to the following common problems and solutions:

ProblemMulig årsagLøsning
Handle does not sit flush with the wall plate.Incorrect Moentrol valve rough-in depth.Verify the valve rough-in depth against the Moentrol valve installation manual. An extension sleeve (sold separately) may be required for proper fit.
Water temperature is too hot or too cold, or difficult to adjust.Temperature limit stop incorrectly set or valve cartridge orientation issue.Refer to your Moentrol valve installation manual for instructions on adjusting the temperature limit stop or verifying cartridge orientation.
Low water pressure from the showerhead.Mineral buildup in showerhead nozzles or partially closed water supply valves.Clean showerhead nozzles. Ensure all water supply valves are fully open.
Leaks from the handle or escutcheon.Loose connections or damaged O-rings/gaskets within the valve.Ensure all trim kit components are securely tightened. If leaks persist, the valve cartridge or seals may need inspection or replacement. Consult a professional.

8. Produktspecifikationer

FeatureSpecifikation
MærkeMøn
ModelnummerT3292
FarveChrome
Finish TypeChrome
Antal håndtag1
Håndtag MaterialeMessing
MonteringstypeVægmontering
Inkluderede komponenterFaucet Trim Kit (Valve Sold Separately)
Hovedstørrelse7 tommer
Produktdimensioner7.4 x 7 x 7 tommer
Varens vægt0.64 ounce
Flowhastighed2.5 gallon pr. Minut
Vandforbrug2.5 gallons i minuttet
CertificeringADA-kompatibel

9. Garantioplysninger

The Moen T3292 Align Moentrol Volume Control Modern Shower Trim Kit is backed by Moen's Limited Lifetime Warranty. This warranty covers defects in material and manufacturing workmanship for the original consumer purchaser. For specific details regarding warranty coverage, terms, and conditions, please refer to the official Moen warranty documentation or visit the Moen webwebsted.

10. Kundesupport

For further assistance, technical support, or to inquire about replacement parts, please contact Moen Customer Service or visit the official Moen website. You can find contact information and support resources at www.moen.com.

Relaterede dokumenter - T3292

Preview Moen badekar/bruserventil med ét håndtag monteringsvejledning
Dette dokument indeholder installationsvejledning og fejlfindingsvejledning til Moen-ventillister til badekar og bruser med ét greb, herunder ventillister til badekar/bruser med ét greb og ventillister til kun bruser med ét greb. Det dækker forskellige typer VVS-indbygning, installationsskemaer, installation af lister, justering af temperaturgrænse, plejeinstruktioner og garantioplysninger.
Preview Moen badekar/bruserventil installationsvejledning og fejlfindingsvejledning
Omfattende installationsvejledning og fejlfindingsmanual til Moen badekar/bruser med enkelt greb og ventillister kun til bruser (model INS10717-2/18), inklusive reservedelslister, trinvise instruktioner, pleje, rengøring og garantioplysninger.
Preview Moen M-CORE 3-seriens brusekabine – hurtigstartguide
Kortfattet guide til installation og forståelse af Moen M-CORE 3-seriens bruseventilsystem, med installationsfordele, ventilmuligheder og trimkompatibilitet.
Preview Moen IVER M-CORE 2-seriens illustrerede reservedelsliste
Illustreret reservedelsliste til Moen IVER M-CORE 2-seriens enkeltgrebs badekar/bruser-armatur, inklusive modelnumrene UT2571, UT2672EP og UT2683EP. Detaljer om reservedelsidentifikation, sætnumre og finishmuligheder.
Preview Moen INS2154C badekar/bruser og kun bruserventil installationsvejledning
Detaljerede installationsvejledninger, styklister og fejlfindingsvejledning til Moen INS2154C badekar/bruser og ventilsæt til kun bruser med regnbruserhoved. Dækker VVS-variationer, installationstrin, justering af temperaturgrænse, garanti og pleje.
Preview MOEN Cambium 3/4" Thermostatic Shower Trim - TS5101 Series Specifications
Detailed specifications for the MOEN Cambium 3/4" Thermostatic Shower Trim (TS5101 series), including faucet description, operation, standards, warranty, and dimensions. Compatible with S3371 valve.