Indledning
Welcome to the instruction manual for your Rexel Auto+ 60X Cross-Cut Paper Shredder. This document provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your device. Please read it thoroughly before use.
Sikkerhedsoplysninger
- Keep hands, loose clothing, hair, and jewelry away from the paper entry slot.
- Lad ikke børn eller kæledyr komme i nærheden af kompostkværnen.
- Tag stikket ud af stikkontakten, når den ikke er i brug, eller før rengøring/vedligeholdelse.
- Makuler ikke metalgenstande, selvklæbende etiketter eller vådt papir.
- Brug kompostkværnen på en flad, stabil overflade.
- Do not attempt to repair the shredder yourself. Contact qualified service personnel.
Opsætning
Udpakning
Tag forsigtigt makulatoren ud af emballagen. Gem emballagen til senere transport eller opbevaring.
Placering
Place the shredder on a level, stable surface near a power outlet. Ensure adequate ventilation around the unit.
Strømtilslutning
Sæt netledningen i en almindelig stikkontakt.
Waste Bin Installation
Ensure the 15-liter waste bin is correctly inserted into the shredder unit. The shredder will not operate if the bin is not properly seated.
Image: The Rexel Auto+ 60X Cross-Cut Paper Shredder with its 15-liter waste bin partially open, revealing shredded paper. This illustrates the shredder's design and waste collection system.
Betjeningsvejledning
Tænder
Locate the power switch or control panel on the shredder. Switch the shredder to the "On" or "Auto" position. The shredder is now ready for use.
Automatic Feed Operation
- Open the automatic feed tray.
- Stack up to 60 sheets of paper (80 gsm) neatly into the automatic feed tray. Ensure there are no folded or crumpled sheets.
- Close the automatic feed tray. The shredder will automatically detect the paper and begin shredding.
- The shredder will stop once all paper in the tray has been processed.
Manuel fremføring
- For single sheets, staples, paper clips, or credit cards, use the manual feed slot.
- Insert up to 6 sheets of paper (80 gsm) or one credit card/stapled document into the manual feed slot.
- The shredder will activate and process the item.
Continuous Operation and Cooling
The shredder is designed for occasional use. It can operate continuously for approximately 4 minutes. After this period, it will automatically enter a cooling down phase to prevent overheating. Allow the shredder to cool for the recommended time before resuming operation.
Tømning af affaldsbeholderen
When the waste bin is full, the shredder may stop operating. Pull out the 15-liter waste bin and dispose of the shredded material. Reinsert the bin securely to resume operation.
Manual Reverse Function
In case of a paper jam, switch the shredder to the "Reverse" position. This will help clear the jam by moving the paper backward. Once cleared, switch back to "Auto" or "On".
Opretholdelse
Rensning
- Tag altid stikket ud af stikkontakten før rengøring.
- Tør ydersiden af makulatoren af med en blød, tør klud. Brug ikke slibende rengøringsmidler eller opløsningsmidler.
- Regularly empty the waste bin to prevent overfilling and potential jams.
Oiling the Shredder (Recommended)
To maintain optimal performance and extend the life of your shredder, it is recommended to oil the cutting blades periodically, especially after emptying the waste bin 2-3 times or if you notice a decrease in performance or increased noise.
- Apply shredder oil (specifically designed for paper shredders) across the paper entry slot.
- Run a few sheets of paper through the manual feed to distribute the oil.
- Alternatively, you can use an oiled sheet (a sheet of paper with shredder oil applied to it) and feed it through the manual slot.
Fejlfinding
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Makulatoren tænder ikke. | Ingen strøm. | Kontroller netledningens tilslutning og stikkontakten. |
| Makulatoren stopper under drift. | Overophedning. | Allow the shredder to cool down for 20-30 minutes. |
| Makulatoren stopper under drift. | Waste bin full or incorrectly inserted. | Empty the waste bin and ensure it is securely reinserted. |
| Papirstop. | Too much paper inserted or paper is crumpled. | Skift til "Reverse" to clear the jam. Reduce the number of sheets for automatic or manual feed. |
| Shredder is noisy or slow. | Knivene skal smøres. | Oil the shredder blades as described in the Maintenance section. |
Specifikationer
- Mærke: Rexel
- Model: Auto+ 60X (2103060)
- Makuleringstype: Cross-Cut
- Sikkerhedsniveau: P3 (4x45mm particles)
- Automatic Feed Capacity: Up to 60 sheets (80 gsm)
- Manuel indføringskapacitet: Up to 6 sheets (80 gsm)
- Strimler: Papir, hæfteklammer, papirclips, kreditkort
- Affaldsbeholderkapacitet: 15 liter
- Kontinuerlig kørselstid: Cirka 4 minutter
- Nedkølingstid: Varies (allow 20-30 minutes after overheating)
- Støjniveau: Under 60 dB
- Strømkilde: El-kabel
- Materiale: Plast
- Varens vægt: 7.7 kilo
- Farve: Sort
- Fabrikant: Acco
Garanti og support
Information regarding specific warranty terms and support contacts is not available in this manual. Please refer to the documentation included with your purchase or visit the official Rexel webwebstedet for detaljerede garantioplysninger og kundesupportmuligheder.
For service or technical assistance, please contact your local Rexel dealer or authorized service center.
