Pyle PDWM4400 4-Channel VHF Wireless Microphone System

Indledning

This instruction manual provides essential information for the proper setup, operation, and maintenance of your Pyle PDWM4400 4-Channel VHF Wireless Microphone System. Please read this manual thoroughly before using the product to ensure optimal performance and longevity.

Reservedelsliste

The Pyle PDWM4400 system includes the following components:

• 1 x 4-Channel Microphone Receiver Base
• 4 x Beltpack Transmitters
• 4 x headsetmikrofoner
• 4 x Clip-on Lavalier Microphones
• 4 x 9V batterier
• 1 x 1/4'' Audio Connection Cable
• Aftagelige rackmonteringsbeslag
• 1 x strømadapter

Opsætningsinstruktioner

1. Receiver Base Setup

1. Place the receiver base on a stable, flat surface or mount it into a standard audio rack using the provided rack mount brackets.
2. Connect the power adapter to the DC input on the rear of the receiver and plug it into a suitable power outlet.
3. Attach the integrated antennas to the ANT A and ANT B connectors on the rear of the receiver. Ensure they are securely tightened and positioned for optimal signal reception.
4. Connect the 1/4'' Audio Connection Cable from the MIX OUT jack on the receiver to the input of your PA system, amplifier, or mixer. For individual channel control, use XLR cables (not included) to connect the AF OUTPUT BALANCED jacks to your mixer.

2. Senderopsætning

1. Open the battery compartment on each beltpack transmitter.
2. Insert one 9V battery into each transmitter, observing correct polarity.
3. Connect either a headset microphone or a clip-on lavalier microphone to the input jack on the beltpack transmitter.
4. Secure the beltpack transmitter to your clothing using the integrated clip.

Betjeningsvejledning

1. Tænd/sluk

• To power on the receiver, press the POWER ON/OFF switch located on the front panel. The display will illuminate.
• To power on each beltpack transmitter, slide the power switch to the ON position. The display on the transmitter will show its operating frequency.
• For at slukke skal du udføre trinnene i omvendt rækkefølge.

2. Lydstyrkekontrol

• Each channel on the receiver base has an independent volume control knob. Rotate the knob clockwise to increase volume and counter-clockwise to decrease.
• Adjust the volume levels to achieve a balanced audio output without distortion.

3. Signal Indicators

• The RF (Radio Frequency) indicator on the receiver will light up when a signal is being received from the corresponding transmitter.
• The AF (Audio Frequency) indicator will light up when audio is being transmitted through the channel.

Opretholdelse

1. Udskiftning af batteri

• When the battery indicator on the beltpack transmitter shows low power, replace the 9V battery immediately to avoid interruption during use.
• Always use fresh, high-quality batteries for best performance.

2. Rensning

• Tør modtageren og senderne af med en blød, tør klud.
• Brug ikke flydende rengøringsmidler eller opløsningsmidler, da de kan beskadige overfladen eller de indvendige komponenter.

Fejlfinding

• Ingen lyd: Ensure all components are powered on, batteries are fresh, and cables are securely connected. Check volume levels on both the receiver and your audio system.
• Statisk elektricitet eller interferens: Verify that the antennas are properly attached and positioned. Ensure the operating range (up to 240+ ft) is not exceeded. Minimize obstructions between transmitters and receiver.
• Svagt signal: Replace batteries in transmitters. Ensure antennas are fully extended and positioned correctly.

Specifikationer

• Microphone System Type: Quartz Control VHF
• Trådløs driftsområde: Up to 240'+ ft.
• Signalstabilitet: +/- 0.005 %
• Dynamisk område: >100dB
• Falsk afvisning: 80dB
• Total Harmonic Distortion (T.H.D.): <0.5 %
• Sender batteri: (1) x 9V Battery (Each)
• Strømforsyning: 110/220V
• Receiver Base Dimensions (L x W x H): 16.5'' x 8.2'' x 1.8'' -inches

Officiel produktvideo

Garanti & Support

This product comes with a warranty. Please note that the warranty does not cover misuse of the product. For detailed warranty information or technical support, please refer to the official Pyle webwebsted eller kontakt deres kundeservice.

For mere information, besøg Pyle Store.