TOOLTOP ET14S Thermal Imager Macro Lens User Manual

1. Produktet er slutview

The TOOLTOP ET14S Macro Lens is a dedicated accessory designed to enhance the close-up imaging capabilities of the TOOLTOP ET14S Thermal Imager. It allows for detailed thermal inspection of small components and circuits by reducing the minimum focus distance.

Important Note: This macro lens is specifically designed for the ET14S thermal imaging multimeter and is not compatible with ET15S, ET13S, or other models.

2. Opsætning og installation

Follow these steps to correctly install the macro lens onto your TOOLTOP ET14S Thermal Imager:

1. Gently tilt the macro lens for proper alignment during installation.
2. Insert the front two corners of the macro lens into the designated card slot on the thermal imager.
3. Press the back of the macro lens firmly until the entire lens assembly is securely seated within the card slot.

3. Betjeningsvejledning

Once installed, the macro lens allows for close-up thermal imaging. Observe the following guidelines for optimal performance:

• The optimal working distance for the macro lens is approximately 2.5 cm from the target object.
• If the distance to the object exceeds 2.5 cm, the image may become blurred. In such cases, remove the macro lens and use the thermal imager in its normal operating mode.
• When using the macro lens, it may be necessary to slightly move the macro lens left and right to achieve the clearest focus on the target area.

4. Vedligeholdelse

To ensure the longevity and performance of your macro lens:

• Keep the lens clean and free from dust and smudges. Use a soft, lint-free cloth specifically designed for optical lenses.
• Avoid touching the lens surface with bare hands.
• Store the macro lens in a protective case when not in use to prevent scratches and damage.
• Do not expose the lens to extreme temperatures or harsh chemicals.

5. Fejlfinding

If you encounter issues with your macro lens, consider the following:

• Sløret billede: Ensure the working distance is approximately 2.5 cm. If the object is too far or too close, the image will be out of focus. Try slightly adjusting the lens position (left/right) as mentioned in the operating instructions.
• Objektivet sidder ikke ordentligt fast: Verify that the front two corners are correctly inserted into the card slot before pressing the back of the lens. Ensure no debris is obstructing the slot.
• Kompatibilitetsproblemer: Confirm that your thermal imager is indeed the TOOLTOP ET14S model. This macro lens is not compatible with other models.

Hvis problemerne fortsætter, kontakt kundesupport for yderligere hjælp.

6. Specifikationer

7. Garanti og support

For garantioplysninger, teknisk support eller eventuelle produktrelaterede forespørgsler, bedes du kontakte producenten eller dit købssted. Behold din købskvittering som købsbevis.