1. Introduktion
The Bayrol Salt Relax Pro 70 m³ is an advanced salt chlorinator system designed for automatic disinfection of swimming pool water. This system utilizes salt electrolysis to produce chlorine from a low concentration of salt in the pool water, ensuring clean and hygienic conditions for pools up to 70 cubic meters. Its self-cleaning cell and user-friendly interface make it an efficient and reliable solution for pool maintenance.
2. Sikkerhedsoplysninger
Please read all safety warnings and instructions carefully before installing, operating, or performing maintenance on the Bayrol Salt Relax Pro. Failure to follow these instructions may result in injury, electric shock, or damage to the equipment.
- Sørg for, at strømforsyningen er afbrudt før installations- eller vedligeholdelsesarbejde.
- Installationen skal udføres af en kvalificeret tekniker i overensstemmelse med lokale el- og VVS-forskrifter.
- Keep the unit away from direct sunlight and ensure adequate ventilation.
- Do not operate the system if any part is damaged or if there are signs of leakage.
- Maintain proper salt levels in the pool water as specified in this manual to prevent damage to the cell and ensure effective disinfection.
- Hold børn væk fra enheden under drift.
3. Opsætning og installation
Proper installation is crucial for the optimal performance and longevity of your Salt Relax Pro system. Follow these steps carefully:
- Mounting the Chlorinator: Install the salt chlorinator unit in a dry, well-ventilated area, away from direct sunlight and heat sources. Ensure it is mounted securely according to the provided installation diagram in the separate installation guide.
- VVS tilslutning: Connect the chlorinator cell into your pool's filtration system plumbing. The cell should be installed after the filter and heater, but before any return jets. Ensure all connections are watertight.
- Elektrisk tilslutning: Connect the chlorinator to a dedicated and properly grounded electrical outlet. Ensure the power supply matches the unit's requirements. It is recommended to have a qualified electrician perform this step.
- Adding Salt to the Pool: Add the recommended quantity of salt to your pool water. The Salt Relax Pro operates effectively with salt concentrations starting from 1.5 g/l. Refer to the table below for initial salt dosage based on pool volume. Distribute the salt evenly and allow it to dissolve completely before starting the system.
Figure 1: Bayrol Salt Relax Pro 70 m³ Salt Chlorinator unit. This image displays the main unit of the salt chlorinator, typically installed as part of the pool's water treatment system.
4. Betjeningsvejledning
Once installed and the salt has dissolved, you can begin operating your Salt Relax Pro system:
- Tænd: Turn on the main power switch for the chlorinator. The display will illuminate, indicating the system is active.
- Setting Chlorine Production: Use the control panel to adjust the desired chlorine production level. The system allows for easy adjustment to meet your pool's specific needs. Start with a moderate setting and adjust as necessary based on water testing results.
- "Shock Chlorination" Function: For initial pool cleaning, or if the pool water requires a rapid increase in chlorine levels (e.g., after heavy use or rain), activate the "Shock Chlorination" function. This feature boosts chlorine production for a set period to quickly sanitize the water. Refer to the user interface for specific activation steps.
- Overvågning: Regularly monitor your pool's water chemistry (chlorine, pH, alkalinity, stabilizer) to ensure optimal balance and effective disinfection. Adjust the chlorinator's output as needed.
5. Vedligeholdelse
Regular maintenance ensures the efficiency and longevity of your Bayrol Salt Relax Pro system:
- Kontrol af saltniveau: Regularly check the salt level in your pool water. The system will typically alert you if salt levels are too low. Replenish salt as needed to maintain the recommended concentration.
- Cellerengøring: The Salt Relax Pro cell is designed to be self-cleaning, which helps maintain consistent chlorine production regardless of water hardness. However, annual inspection and manual cleaning may be required, especially in areas with very hard water. The cell is easy to disassemble for this purpose.
- To clean, disconnect power, remove the cell, and inspect for scale buildup.
- If scale is present, soak the cell in a mild acid solution (e.g., diluted muriatic acid or a commercial cell cleaning solution) following the manufacturer's instructions.
- Skyl grundigt med frisk vand før genmontering.
- Vinterisering: If you close your pool for winter, follow the manufacturer's guidelines for winterizing the Salt Relax Pro system. This typically involves draining the cell and storing it in a frost-free environment.
6. Fejlfinding
This section provides solutions to common issues you might encounter with your Salt Relax Pro system.
| Problem | Mulig årsag | Løsning |
|---|---|---|
| Low Chlorine Production | Low salt level, dirty cell, low water flow, incorrect setting. | Check and adjust salt level. Clean the cell. Ensure pump is running and filter is clean. Increase chlorine production setting. |
| "No Flow" Error | Insufficient water flow through the cell. | Check pool pump operation. Ensure filter is clean. Inspect plumbing for blockages. |
| "Low Salt" Error | Salt concentration below recommended level. | Add recommended amount of salt to the pool. Allow time for dissolution and circulation. |
| Systemet tænder ikke | No power supply, tripped breaker, faulty wiring. | Check power outlet and circuit breaker. Verify electrical connections. Contact a qualified electrician if issues persist. |
If you encounter issues not listed here or if solutions do not resolve the problem, please contact Bayrol customer support or a qualified pool technician.
7. Specifikationer
- Model: Salt Relax Pro 70 m³
- Mærke: Bayrol
- Referencenummer: 190000
- ASIN: B07CLRVXGW
- Pool Volume Capacity: Op til 70 m³
- Salt Concentration Requirement: From 1.5 g/l
- Produktform: Granular (referring to salt, not the device itself)
- Produktfordele: Kills bacteria, kills algae, prevents scale, prevents corrosion, maintains clean and disinfected water.
- Pakkedimensioner: 42.2 x 30.2 x 29.8 cm
- Pakkevægt: 10.55 kg
- Fabrikant: Bayrol
- International Article Number (EAN): 04059797016233
- Antal varer: 1
8. Garanti og support
For warranty information, please refer to the documentation provided with your purchase or visit the official Bayrol webwebsted. Gem din købsbevis til garantikrav.
For technical support, spare parts, or further assistance, please contact Bayrol customer service. Contact details can typically be found on the manufacturer's webwebstedet eller i din produktemballage.
- Fabrikant Webwebsted: www.bayrol.com (Examplinket, det faktiske link kan variere)
- Kundesupport: Refer to your local Bayrol distributor or contact information provided in the product box.
