HTC Shear Model 250-10A Installation & Operating Instruction Manual

2.1 Generel sikkerhed

• Always wear appropriate personal protective equipment (PPE), including safety glasses, gloves, and steel-toed boots.
• Sørg for, at arbejdsområdet er rent, godt oplyst og fri for forhindringer.
• Never operate the shear under the influence of drugs or alcohol.
• Kun uddannet og autoriseret personale må betjene eller vedligeholde dette udstyr.

2.2 Elektrisk sikkerhed

• Sørg for, at maskinen er korrekt jordet.
• Afbryd strømmen, før du udfører vedligeholdelse eller justeringer.
• Må ikke anvendes med beskadigede netledninger eller stik.

2.3 Hydraulic Safety

• Check hydraulic fluid levels regularly.
• Be aware of high-pressure hydraulic lines; leaks can cause serious injury.
• Use only recommended hydraulic fluids.

3.1 Udpakning og inspektion

Carefully unpack the HTC Shear Model 250-10A. Inspect all components for any shipping damage. Report any damage to the carrier immediately. Verify that all parts listed in the packing list are present.

3.2 Forberedelse af stedet

The shear requires a level, stable concrete foundation capable of supporting its weight and operational forces. Ensure adequate space around the machine for safe operation and maintenance access. Provide proper ventilation and lighting.

3.3 Elektrisk tilslutning

Connect the shear to a dedicated electrical circuit as specified in the electrical requirements section (refer to Section 7). Ensure all connections comply with local electrical codes. A qualified electrician should perform this step.

3.4 Hydraulic System Initial Fill

Fill the hydraulic reservoir with the recommended hydraulic fluid (refer to Section 7) to the specified level. Bleed air from the hydraulic system according to the detailed procedure outlined in the service manual.

4.1 Tjekliste før brug

• Verify all safety guards are in place and functional.
• Kontroller hydraulikvæskeniveauet.
• Undersøg knivene for skarphed og skader.
• Ensure the work area is clear.
• Confirm emergency stop buttons are accessible and operational.

4.2 Start af maskinen

1. Drej hovedafbryderen til "ON"-positionen.
2. Press the "START" button on the control panel.
3. Allow the hydraulic pump to build pressure (indicated by pressure gauge).

4.3 Shearing Procedure

1. Position the material to be cut firmly against the back gauge and hold-downs.
2. Ensure fingers and clothing are clear of the blade area.
3. Activate the shear cycle using the foot pedal or control buttons.
4. Wait for the blade to complete its cycle and return to the up position before removing the cut material.

4.4 Standsning af maskinen

• Press the "STOP" button on the control panel.
• Turn the main power switch to the "OFF" position when finished operating or leaving the machine unattended.
• In an emergency, press the nearest emergency stop button.

5.1 Daglig vedligeholdelse

• Clean the machine, removing all metal scraps and debris.
• Kontroller hydraulikvæskeniveauet.
• Inspect blades for wear or damage.
• Lubricate moving parts as specified in the lubrication chart.

5.2 Ugentlig vedligeholdelse

• Check and adjust blade gap if necessary.
• Inspect hydraulic hoses and fittings for leaks.
• Rengør eller udskift luftfiltre.

5.3 Periodisk vedligeholdelse

• Change hydraulic fluid and filter (every 2000 operating hours or annually).
• Inspect electrical connections for tightness.
• Calibrate back gauge and other measuring systems.