Streamlight Stinger LED HL 120/DC PB

Streamlight Stinger LED HL 120/DC PB Flashlight

Brugervejledning

1. Introduktion

This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.

Sikkerhedsoplysninger

  • Do not look directly into the LED light. The intense beam can cause temporary vision impairment.
  • Opbevares utilgængeligt for børn.
  • Use only Streamlight approved batteries and charging equipment.
  • Do not attempt to disassemble the flashlight head or battery pack.
  • Avoid exposing the flashlight to extreme temperatures or corrosive liquids.
Streamlight Stinger LED HL 120/DC PB Flashlight

Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.

2. Opsætning

2.1 Første batteriopladning

Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.

  1. Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
  2. Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
  3. The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
  4. Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.

2.2 Battery Installation (if required)

The battery is typically pre-installed. If you need to replace or install the battery:

  1. Skru lommelygtens bagdæksel af ved at dreje den mod uret.
  2. Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
  3. Skru endehætten på igen med uret, indtil den er forsvarligt fastspændt.

3. Betjeningsvejledning

The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.

3.1 Tænd/sluk og valg af tilstand

  • Sådan tænder du: Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
  • Sådan skifter du mellem tilstande: With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
  • To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
  • Sådan slukker du: Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.

3.2 Recharging the Flashlight

When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.

4. Vedligeholdelse

4.1 Rengøring

  • Wipe the flashlight body with a damp klæde. Brug ikke slibende rengøringsmidler eller opløsningsmidler.
  • Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.

4.2 Batteripleje og udskiftning

  • For optimal battery life, avoid fully discharging the battery before recharging.
  • If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
  • Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.

4.3 Opbevaring

Opbevar lommelygten på et køligt, tørt sted væk fra direkte sollys og ekstreme temperaturer.

5. Fejlfinding

Se tabellen nedenfor for almindelige problemer og deres løsninger.

ProblemMulig årsagLøsning
Lommelygten tænder ikke.Battery is depleted or improperly installed.Recharge the battery. Check battery orientation. Ensure tail cap is tightened.
Lyset er svagt eller flimrer.Low battery charge. Loose connections.Recharge the battery. Ensure tail cap is tightened. Clean charging contacts.
Lommelygten oplades ikke.Charger not powered. Dirty charging contacts. Faulty battery or charger.Check power outlet. Clean charging contacts on flashlight and charger. Try a different power source. Contact customer support if issue persists.

6. Specifikationer

FeatureDetalje
ModelStinger LED HL 120/DC PB
LyskildeLED
Hvid lysstyrke800 lumen (høj)
StrømkildeBatteridrevet
BatteritypeNiMH (nikkel-metalhydrid)
Antal batterier1 (inkluderet)
MaterialeAluminium, metal
FarveBlå
Særlige funktionerRechargeable, Multiple lighting modes (High, Medium, Low, Strobe)
VandmodstandsniveauIkke vandafvisende
Varens vægt3 pund

7. Garantioplysninger

Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight webwebstedet eller garantikortet, der fulgte med dit køb. Gem din købsbevis til garantikrav.

8. Kundesupport

If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.

© 2026 Streamlight. All rights reserved. Streamlight and Stinger are registered trademarks of Streamlight, Inc.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.