Webeh 7515

Weber 7515 Catch Pan and Holder Instruction Manual

Model: 7515

1. Om produktet

De Weber 7515 Catch Pan and Holder is a genuine Weber replacement part designed to collect drippings during grilling. It is ideal for indirect cooking, catching grease, and preparing gravy drippings. This accessory helps maintain the cleanliness of your grill and prevents flare-ups.

Nøglefunktioner:

  • Ægte Weber replacement part
  • Fits Spirit (does not fit side mount control panel models after 2008, or front-mounted control panel models), Genesis 1000-5500, Genesis Silver/Gold/Platinum, Platinum I/II, and Summit (except Gold/Platinum 6-burner) gas grills
  • Varens vægt: 1.3 pund
  • Out of Carton Dimensions: 9.1 x 7.3 x 3 inches

2. Hvad er inkluderet

Pakken indeholder:

  • 1 x Weber Catch Pan and Holder
  • 1 x Blanket (as per product information, though typically refers to packaging or insulation)

3. Opsætning og installation

Follow these steps to properly install your Weber 7515 Catch Pan and Holder:

  1. Identificér drypbakkens åbning: Locate the designated slot at the bottom of your compatible Weber gas grill where the catch pan system is installed. This is typically found beneath the cooking area, accessible from the front or side cabinet.
  2. Insert the Holder: Slide the metal holder into the slot. Ensure it is securely seated and level. The holder is designed to support the disposable drip pan.
  3. Place the Drip Pan: Insert a disposable aluminum drip pan into the metal holder. Ensure the pan sits flush within the holder to effectively collect drippings.
Weber Catch Pan and Holder installed in a grill, with a disposable aluminum pan inside.

Billede 3.1: Den Weber Catch Pan and Holder correctly installed in a grill, ready to collect drippings.

Weber Catch Pan and Holder with a disposable aluminum pan, shown on a wooden surface.

Billede 3.2: Et nærbillede view af Weber Catch Pan and Holder with a disposable aluminum pan, demonstrating its design.

Installationsvideoreference:

Video 3.1: This video demonstrates the installation of a compatible grill catch pan, showing how it fits into the grill's designated slot and how to place a disposable liner.

Video 3.2: This video illustrates the process of removing a used drip pan and inserting a new one into the grill's catch pan holder.

4. Betjening

Når installeret, Weber 7515 Catch Pan and Holder operates passively to collect grease and food drippings from your grill. This system is crucial for:

  • Preventing Flare-ups: By catching excess grease, it reduces the risk of sudden flames caused by fat dripping directly onto hot burners.
  • Opretholdelse af renlighed: It keeps the interior of your grill cleaner, simplifying post-grilling cleanup.
  • Indirekte madlavning: The pan can be used to hold water or other liquids for indirect cooking methods, adding moisture and flavor to your food.

Ensure the drip pan is always in place before operating your grill.

5. Vedligeholdelse

Regular maintenance of your catch pan and holder is essential for optimal grill performance and safety.

Checking and Replacing Drip Pans:

  1. Frekvens: Check the drip pan before each grilling session. Replace it when it is approximately two-thirds full to prevent overflow.
  2. Fjernelse: Carefully slide out the metal holder with the disposable pan. Be cautious as the pan may contain hot grease.
  3. Bortskaffelse: Dispose of the used aluminum drip pan responsibly.
  4. Udskiftning: Place a new disposable aluminum drip pan into the clean holder and slide it back into position under the grill.

Rengøring af holderen:

The metal holder should be cleaned periodically to remove any accumulated grease or residue. Use warm, soapy water and a non-abrasive cloth. Rinse thoroughly and dry completely before reinserting.

6. Fejlfinding

Pan Overflowing:

If the drip pan overflows, it indicates that it was not replaced in time. Always check the pan's fill level before and after grilling. Ensure you are using the correct size disposable liners to maximize capacity.

Pan Not Fitting Correctly:

Bekræft, at Weber 7515 Catch Pan and Holder is compatible with your specific Weber grill model. Refer to the "About the Product" section for compatible models. Ensure the holder is inserted correctly into the grill's slot and that the disposable pan is seated flush within the holder.

7. Specifikationer

MærkeWeber
Modelnavn7515
Produktmål (D x B x H)9.1" D x 7.3" B x 3" H
Varens vægt1.3 pund
Materiale TypeRustfrit stål
Speciel funktionRustbestandig
InstallationstypeFritstående
Anbefalede anvendelserUdendørs grill
UPC077924074288, 885196371543
ASINB000WEPH98
Diagram, der viser dimensionerne af Weber Catch Pan and Holder: Depth 0.5 inches, Height 9.1 inches, Width 7.3 inches. Packaging dimensions are also shown: Height 9.50 inches, Width 7.6 inches, Depth 3.1 inches.

Image 7.1: Product dimensions for the Weber 7515 Catch Pan and Holder.

8. Garanti

Dette produkt leveres med en 1 års begrænset garanti. For specific terms and conditions, please refer to the warranty documentation included with your purchase or contact Weber kundesupport.

9. Support

For further assistance, questions, or to purchase additional accessories, please visit the official Weber website or contact their customer service department. Ensure you have your product model number (7515) available when seeking support.

© 2026 WebAlle rettigheder forbeholdes.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.